BLOWS SERCET BRAKER WHIN I PLUG IN - Hayward 1.5 Hp Northstar High Performance Pump

wire in the rv is connected to the ground in the plug
call in an electrician to find /fix the fault

if it smells a bit sweet id say water leak, but the blue tells me probably oil as well.

Hi anthony krim...
You will need to replace your start capicator for the motor, it is faulty
Please take time to rate me

Depending on how hot it is outside, there may not be a problem. It might just be running all day to try to keep up with the amount of heat that's outside. It'll blow a breaker most likely because it's drawing so many amps through the circuit breaker that it trips.

drain the airtank after every use.....compressors use alot of amps....try a plug that isnt being used by alot of other electronics....the regulator may be bad....regulator os the round dial that shows the 32psi......just unscrew counter clockwise...get new one at lowes or homedepot....wrap threads with teflon tape and reinstall....

replace the "combination switch". (turn signal, hi-lo beam)

GFI's and motor's don't get along with each other,if the motor is just the slightest bit of any moisture,the GFI will pick it up as a ground...Try to run it without the GFI.

That is the code for the older jensen's The parking brake bypass procedure is as follows: 1: Go into AM/FM mode 2: Hit "setup" on the remote control 3: Enter 543210 on the remote, listening for the beep for each number entered 4: A new menu will appear. Touch the button that has the hammer/screwdriver on it in the upper left-hand part of the screen. 5: Select Brake bypass to "ON" and hit the "X" near the bottom of the screen.

unlikely a fault with dryer. try plugging another high consumption item into the socket you use for the dryer ie elec kettle or iron. see if breaker still trips and if so you have fault in socket or house wiring. if you put a plug on the dryer yourself, check you have wired plug correctly