Question about TCL Televison & Video

1 Answer

Tcl l32m19 tv wont turn on woke up the other day and the light on the front was not on

Found out that my tv does not have the infa red light on the front and it will not turn on

Posted by John Paul Mark... on


1 Answer

The Knight

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.


    An expert that got 20 achievements.


    An expert that got 10 achievements.

  • TCL Master
  • 76,407 Answers

Power supply regulator section [mains] to your TV should be troubleshooted. This is a skilled work.

Posted on Jun 27, 2012


5 Related Answers

Adarsh Saroj

  • 1044 Answers

SOURCE: TV was on over night.

Do the following
Check the wall out let and ensure it has power. You can do it by connecting any other device in that out let. If the out let is OK then check the connections at both the ends of the power cord. It can happen that contacts have burnt out due to power surge. Re-fix them. Test the power cord on any other device or outlet to make sure that it is OK. If you still do not get power in your TV then I am afraid you have to replace the fuse OR change the Switch.

Posted on Aug 10, 2011



  • 473 Answers

SOURCE: tv wont turn on just

Issue with Main Logic Board fail to innitiate Due to over power. on the Hi voltage Regulator Check for Capacitor leakage..also white balance board fail to innitate due to distortion accumulation May damage IC Color modulator...Refer to Professional TV Repair
CAUTION DO NOT TURN TV ON Will cause eventual Damage inside ....

Posted on Oct 01, 2010


  • 3 Answers


I'm going throught the exact same thing right now. After the lights quit blinking, and the blue light goes off, does the red lamp light stay on. This usually means your lamp has gone bad ($200.00 plus). But when I ordered the lamp, it did the same thing. Had to have the certified hitachi repair man come out for the and told me it had to be a bad lamp, so I ordered a 2nd one with the same result. He came out again and had to take the TV away, later telling me the ballast must have blown when the original lamp went bad. Another $200.00 part. I haven't fought this one with Hitachi yet but am going to try. The ballast shouldn'e go just because the lamp goes out. The set is only 21/2 years old and I've already had to spend about $700.00 on the light enging replacement and now this lamp and ballast expense. Love the TV but would expect a lot less problems from a $2500.00 top model Hitachi. I'm going to see if they feel the same way, hopefully not but I'm not real optimistic they will care. Hope this helps.

Posted on Dec 17, 2007



  • 1622 Answers

SOURCE: 50 inch plasma wont turn on red light is flashing

Your power supply board is dead, u know basic electronics' and soldering? Most of the times, the power supply board just have dead leakages gases capacitors.These capacitors always bulges up on it top,or puff up on it top.Replaced these gases leakages capacitors will get your tv power stable,and work again.Or tries websites like, to buy a whole refurbish power supply board for the replacement.

Hope this help...

Posted on Sep 18, 2010


bonifacio gomez

  • 1238 Answers

SOURCE: red light flashes on tv but wont turn on

Please take this steps on how to determine the problem:
1. Open the back cover.
2. Check the power supply output...It should have 5vdc for the main board..12vdc or 16vdc for the audio and 24vdc for the back-light inverter..
3. If those 3 voltage supplies have encountered voltage drop...The problem could be on power supply board..
4. If the power supply output is normal..The problem could be on the main board...
5. If the problem is power supply you should check if the capacitors are bulged on the top and try to replaced it..If you can't do that you can purchased new power supply board..
6. If the problem is on main board there is no D.I.Y repair on that so you need to buy a new main board that fits to your TV..
Hope this solution will be helpful..

Posted on Jun 08, 2012

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer


Check the remote control for its infra-red emission. Check it with fresh batteries. Check by pressing all the buttons on it; and see whether all of it generates infrared signal while pressing. If it is found OK, check and replace the infrared sensor inside the TV. If you wish to get some details; check the site linked here. It has details about how to check a remote control; by one among the post. Surf the site with patience. Pull up older posts. If the remote control is found OK; check and replace the infra-red sensor inside the TV. Contact any service technician.

Feb 23, 2015 | Televison & Video

1 Answer

Wont power on and red light isnt on

Main power supply regulator board damaged. Check and replace it.

Dec 08, 2013 | RCA 46" Class LCD 1080p 60Hz HDTV,...

1 Answer

Red status light is on but not blinking and picture wont show at all???

access the self diagnosis feature by pressing the menu and device/input buttons on the tv both together and hold them for 6 seconds then counr the teo digit blink code.

Mar 11, 2013 | Mitsubishi WD-62725 62" Rear Projection...

1 Answer

Why wont my tv turn on

Do any indicator LED at it front panel lights up? If lights up, and the TV won't turn ON, the fault is with its internal circuit board. If not, the fault is with its power regulator board.
This is the picture to the power board to your tV.2_7_2012_4_24_00_pm.jpg

Feb 07, 2012 | Zenith Z50PX2D 50 in. Plasma HDTV

1 Answer

My tv won't turn on at all. The red light is on in front of the tv so there is power...batteries in remote are new

Can you turn it on from the front controlls?

If so, open the back off the TV and follow the PC board foils from where the infa-red receiver is, the part that you aim the remote at, assuming that the remote is for sure putting out pulses which you can buy a infared detection card at circuit city and aim the remote at it first and you will be able to visably see the light emitting from the hand set, and also I have found that if you take the remote appart, you will have to most of the time clean it with iso alchohol as well as the rubber pad's, and the infared emitting diode in the handset sometimes has cold solder joints and need's re-soldering.Failing that, you have to then follow the foil from the receiver unit in the metal can inside the front of the TV, and it will lead to a receiver ic chip, and I have found that ESP. in Toshiba and Panasonic's that the chip is defective, and just replace it, providing there is a signal from the receiver getting to it from the hand set which you can easily see if you have an analog meter set to the 100mv level, and the needle will be pulsing up and down, but if nothing is coming out of that chip, then replace the chip which you can get at Main Electronics at 604-872-0267, ask for Mike!

I hope this is of help to you!

[email protected]

Aug 14, 2009 | iLO 3200 32 in. LCD Television

1 Answer

Daewoo DSL-17DW3 NO RESONSE at all, remote nor manual

There is a problem with these, common to many other badly designed TVs. They get too hot for the capacitors which dry out and cause all sorts of probs.

May 18, 2009 | Daewoo DSL-17DW3 17.1 in. HD-Ready LCD...

1 Answer

My k800i wont turn on. just the infa red led flashes

when k800i is in battery low, infrared led will blink... try to charge your battery of buy another one.

Nov 16, 2008 | Sony Ericsson K800i Cellular Phone

1 Answer

Mobile phone wont turn on

it seem like you mobile phone is infected and you must format or flash you mobile O/S which will make you mobile phone new

Sep 15, 2007 | Sony Ericsson K800i Cellular Phone

Not finding what you are looking for?
Televison & Video Logo

Related Topics:

5,068 people viewed this question

Ask a Question

Usually answered in minutes!

Top TCL Televison & Video Experts

The Knight
The Knight

Level 3 Expert

76407 Answers

Lawrence Oravetz

Level 3 Expert

10548 Answers

john h

Level 3 Expert

23424 Answers

Are you a TCL Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides