Toshiba MD13N3 13 in. TV/DVD Combo Troubleshooting

• 11963
• 11603
• 12746
• 12260
• 10587
• 12070
• 11990
• 10178
• 10030

1. Turn on your TV/DVD combo and point the Magnavox universal remote at it.
2. Press and hold the "Code Search" button on the remote until the LED light on the remote turns on and stays on.
3. Press the "TV" button on the remote to program the remote to control your TV.
4. Enter one of the codes listed above using the number buttons on the remote. The LED light on the remote should turn off if the code is accepted.
5. Test the remote by pressing the "Power" button to turn on the TV/DVD combo. If it works, try other buttons on the remote to control your TV/DVD combo.
6. If the first code you entered doesn't work, repeat steps 2 to 5 with another code until you find the correct one.

[1] Turn on a desired device (e.g.,VCR or DVD player) and, if
applicable, insertmedia (e.g., cassette or disc).

NOTE: Please read steps 2 through 4 completely before proceeding.

Highlight or write down the codes and device you wish to program
before starting step 2.

[2] On the remote control,press a device key once (i.e., VCR/PVR,
DVD,CBL/SAT,or TV).

NOTE: To program control of a VCR, PVR (or DVR),TV/VCR Combo,

or TV/VCR/DVD Player Combo press VCR/PVR once.After programming

a VCR Combo device, you will be able to control channel selection,

volume,andVCR functions.

NOTE: To program control of a DVD Player,DVD Player/VCR

Combo, or TV/DVD Player Combo, press DVD once.After programming

a DVD Combo device, you will be able to control channel selection,

volume, and DVD functions.

NOTE: To program control of a Cable Box, Cable Box/PVR (or DVR)

Combo, Satellite Receiver, or a Satellite Receiver/PVR (or DVR)
Combo, press CBL/SAT once.

[3] Press and hold SET until the LED (red light) blinks twice,
then release SET.

[4]Use the Manufacturer's Codes to

locate the type of device and brand name and then enter

the first four-digit code for your device. If performed correctly,
the LED will blink twice.

NOTE: If the LED did not blink twice, repeat steps 2 through 4 and enter
the same code again

[5] Aimthe remote control at the device and press POWER

once.The device should turn off. If it does not, repeat

steps 2 through 5, trying each code for your brand until

you find one that works. If it still doesn't work, try
Searching For Your Code on next page.
NOTE: If the device does not have a POWER key, press PLAY
OK.