Kitchenaid commercial range KDRP707RSS01 error code F 04

We are FIXYA dot com, we aren't Kitchen Aid.

You error needs a service call, because it probably needs a new control board. These aren't cheap so it needs professional diagnosis.

https://www.google.com/search?q=AM71+UI71+EEKGO-010+error+04

..

Hi,

In front of the 04 code, what is the "F" code is needed for help you. There are 4 different possible answers for this issue.

FAILURE/ERROR DISPLAY CODES Before proceeding with any corrective action, perform the following steps to enter the Diagnostics mode: 1. To recall last failure code, if not displayed, press the Cancel key to place the range in an idle state. 2. Press the Cancel and Start keys in the following order: CANCEL, CANCEL, START. 3. Verify the error code displayed on the control by observing for longer than 1 minute. If the error returns, use the applicable procedure listed below for the actual error code that is displayed.

With this information, I can narrow down the cause and possible repair on you unit. Thanks

I’m happy to help further over the phone at https://www.6ya.com/expert/gere_bf68e6055dd61249

KitchenAid Fault Codes - AppliancePartsPros.com

www.appliancepartspros.com/repair-help/kitchenaid-fault-codes.html

Jump to Kitchen Aid Range / Stove / Oven Fault Codes - Failure Code, Fault CodeDescription, Solution ... F1 - E6, Latch signal mismatch error ... F3 - E0, Oventemperature ... electronic control will display F6 ...

disconnect the range form the power source, you should hear a pomp and the door should open

This is a recurring problem with certain KitchenAid ranges. I have a 15 year old dual fuel 36" range and have replaced the temp sensor twice, and now it has gone out again. $8,000 piece of junk the oven has been used. RARELY in 15 years.

I have a dual fuel kitchenaid convection range and I put it in self cleaning mode last night. Afterwards it said F 04 on the display. The doors open again, but neither of the ovens work

Replace the electronic range control ERC

access kitchenaid fault codes

Hi.

F2 E1 is a keypad connection error.

Here the complete list of Kitchenaid error codes:
Troubleshooting KitchenAid oven, range and...

Google kitchenaid error codes...

I have had three ranges and at least five circuit boards so far... they are garbage, if under warranty, call and complain LOUD.