Can it be Fixed or just trash?

driver's door where door harness is cut inside rubber cover many wires are

I think the previous owner needs some heat--inspec system-the vacuum controls on the panel cud hav issues or the heater door or the core itself--get a repair manual from fixya or a parts place

Not one coil,both coils. Replace them both and make certain the exhaust vent is not blocked.

There is a eletronics parts thats has a cold solder on it. Maybe there is a cable or wire is barely touching on the connector inside the main pcb board. See technician to check your tv. Don't let this problem will continue, bacause some of the electronics will be damage.

Connect it to the computer you usually connect it to and use the restore button in iTunes. This will reset the device to manufacture settings and remove any passwords. If you recently aquired this ipod and the previous owner set the password you will need to get it off him/her.

All the best
Sean

is the motor rotating the right way? did the wires get swiched when you fixed the plug?

It is most likely the vertical deflection IC has overheated and lost its soldering. If you open your TV up, it is a 10-15 pin in a row IC sticking out of the motherboard attached to a heatsink. It should be labeled "IC451." Give it a wiggle, see if it affects the picture, You may have to resolder them in place.

The IC may be hard to find, look for a peice of metal that is sticking out of the motherboard, attached to a small chip. I fixed a samsung tv that had it in the middle area.

maybe the lamp

Best thing for you would be to call in a pro as a TV set IS NOT the place to be experimenting around inside of.

This is a DLP projection TV from the model you posted I guess. Is there any kind of light on the screen at all such as on screen displays? This is the first step in trying to isolate the problem.