YAMAHA SOUNDBAR PROTECTIVE MODE

Great product, horrible instructions that focused on every language known to man rather than clear steps. Hope this helps....for the JAMO TORSTEN 2 WAY SOUNDBAR W/ WIRELESS 10" SUB 360 Series, as well as other Klipsch soundbars.

If the SoundBar is in STANDBY mode (solid RED status light), push the <SOURCE> button on the SoundBar until the status light is solid GREEN.

STEP ONE (Place the unit in learning mode): With the status light showing solid GREEN, press and hold the <SOURCE> and <MUTE> buttons on the front of the SoundBar at the same time (approximately 3 seconds) until the status light flashes RED and GREEN.

STEP TWO (Select the function to learn): Press the <MUTE> button once on the SoundBar (the status light changes to solid ORANGE).

STEP THREE (Learn the function): Hold your remote control within one foot and pointed at the front of the SoundBar. Slowly press the <MUTE> button on your remote control four times. On the first three presses, the status indicator light will flicker ORANGE with each press. If the unit has successfully learned the function, on the fourth press of the button, the light will flash GREEN several times and then turn to solid GREEN.

To program the remaining functions, simply repeat all steps, substituting <MUTE> with the new function and button presses (VOLUME UP, and VOLUME DOWN) on steps TWO and THREE.

I had the same problem with my U-verse s10-10 remote and a yamaha SR 300 soundbar. Here is how I got my volume control (but NOT power control) on the yamaha working:


First - always send volume control to the AUX button:
Press and hold AT&T key and OK for 1 second, release, look for 2 flashes.
Now press AUX button. The AUX button will show a long flash.

Second - Go through the manual programing steps listed in the guide for the AUX button (hold AUX and OK for 1 second, release; 2 flashes, punch in code). But instead of pressing the Power button to try to turn off your yamaha soundbar, press the volume up / down and Mute button. I think the code that worked for me was 4045 but I honestly don't remember.

The key is that you have to send the volume control to the AUX button first or it's all a wash.

There are no codes available for a 6.4 remote on a Vizio Soundbar. Below are the steps to Power Scan the remote control. This will search all codes 1 by 1 until it finds a code that works, or exhausts all available codes.


Power Scan:

1.) With the Soundbar on, press and hold the AUX mode button (about six seconds) on top of the remote until all mode button backlights come on, then release.

2.) Press 2 then press STAR (*)

3.) Press the Up arrow button once a second while pointing the remote at the Soundbar. If the code for the Soundbar comes up, it will power off.

4.) Press the POUND (#) button. If the code entered is valid for the remote, the mode light flashes three times. To verify the code works try several different functions for that equipment.

Tommy Faust
DISH Social Media Representative

Unfortunatly your ps3 is dead, I am sorry for your loss.

connection problems or power surge connect to surge protecter

Yellow light of death =[. sorta like the Xbox's red circle of death. Your system is crashed just cuz of old age. you needa buy something neww

yellow light of death, ring playstation

its over heated

what should be done when it flashes red

your ps3 is done. this is known as the yellow light of death.