Flashing and beeping

The beeping and flashing lights on your Currys C510WM11 washing machine after a complete cycle may indicate an error or issue with the machine. Here are a few steps you can take to troubleshoot the problem:

Check the user manual: The manual may have information on what the flashing lights and beeping mean. Check the troubleshooting section to see if there are any tips on how to resolve the issue.

Check the door: Ensure that the door is properly closed and latched. If the door is not closed properly, the machine will not start or complete a cycle.

Check the water supply: Make sure that the water supply to the machine is turned on and that the hoses are not kinked or clogged.

Check the drain: Ensure that the drain hose is not kinked or clogged. If the drain is clogged, the machine may stop mid-cycle and beep.

Check the carbon brush: Make sure that the carbon brush is installed correctly and that it is making proper contact with the motor. If the brush is not installed correctly, the machine may not function properly.

If you have tried these steps and the issue persists, you may need to contact a professional repair technician to diagnose and fix the problem.

https://removeandreplace.com/2015/12/21/dishwasher-has-beeping-sounds-blinking-lights-how-to-reset/
Dishwasher lights flashing or blinking. The heating element heats up the water to operating temperature. If the water doesn't reach the proper temperature after a set amount of time, a light on the control panel might start flashing. ... If the drain pump is not working, a light on the control panel might start flashing. https://www.repairclinic.com/RepairHelp/How-To-Fix-A-Dishwasher/28---/Dishwasher-Lights-Flashing-Or-Blinking
Flashing lights and or beep sounds can mean the dishwasher problem was from a power surge or power outage. You can unplug the dishwasher from power or shut off the breaker to the dishwasher for 1 minute. This may reset the dishwasher and get it back to working order.
https://removeandreplace.com/2015/12/21/dishwasher-has-beeping-sounds-blinking-lights-how-to-reset/

You need to supply brand and model numbers in the question itself when posting.


https://www.ifixit.com/Answers/View/116311/Why+does+my+washer+stop+half+way+through+cycle

https://diy.stackexchange.com/questions/21181/what-could-cause-my-washing-machine-to-stop-before-the-rinse-cycle

http://www.whitegoodshelp.co.uk/washing-machine-sticks-stops-mid-cycle/

http://appliances.wonderhowto.com/how-to/fix-your-front-load-washer-if-stops-mid-cycle-381047/

the drain pump is probably blocked or overheating, when it starts beeping which lights are flashing reading from right to left e.g. 1,3,5 also what is the model number?

check the filter

Check your sink drain to see if you dishwasher is able to exhaust water out. The exhaust drain hose, or the drain is plugged. They get debrea from food being washed off the dishes.

f/h is a "no water entering " fault code. check incoming watersupply first, then check hte inlet watervalve screens for blockage

try removing the bottom front panel and see if there is something blocking the drain.

I used the self cleaning mode for 2 hours and the error f2 keeps flashing and beeping, I did try to power off with the breaker and left it off for about a half hour and it still continues to beep and flash f2, what should I do?