U11 error code on Panasonic DMR-HS2

i am 100% sure that it is the play head of your md 9000 that is dirty or faulty
solution
1)get a play head cleaner,put your cam in playback mode then play it to the end,then you can now confirm with a new tape
2)if solution 1 do not solve your problem you need to change the play head of the cam

Hi,

Usually, the U11 error code in a Panasonic DVD player indicates an optical problem. You could of course try doing a cleaning using a CD cleaner normally readily from computer parts stores. Alternately, you can open the unit up and do a manual cleaning with soft bristle brush and/or cotton buds. Other than that, it could be indicative of a weakening laser eye which of course would require parts replacement.

Hope this be of initial help/idea. Pls post back how things turned up or should you

need additional information.

Good luck and kind regards.

Thank you for using FixYa..

You could try using a DVD lens cleaner (wet or dry type, whichever is available; but it MUST be the manufacturer's recommended DVD lens cleaner (or suitable equivalent) - do not use CD/DVD generic cleaners, they might be cheaper, but these do not work and may damage the unit).

If after following the directions on the pack, the recorder still shows U11, then the drive is probably on its way out. Considering the cost of a new DVD-RAM drive is around $300 or so, plus labour (if applicable), it may not be economical in the long term.

Nevertheless, try cleaning the laser lens (either with the DVD cleaner discs), see how you go. I usually try to avoid opening drive units up in cases of cleaning, however, I have found short bursts of compressed air through the drive from front to back usually solves most dust-related problems.

If you are trying to run a recorded DVD (saved a video or movie on to it), it could be the quality of the disc. I would recommend buying quality DVD's, the lower quality ones can create read errors (U11).

u11 is not a valid error code - please recheck.



Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question

U11 means "incompatible disc"
Either you are trying to read a disc outside your region (region 1 discs required for U.S.) or the player has gone bad.

Has anyone found a solution? I was recording movies everyday and then it stopped and says U11. I am using the same discs as before.

hi i try to this,but nothing still the same!!!!

Does anyone have information about
IC MR6710 datasheet and/or where to order it?
It is an power sply device of PANASONIC S325 DVD Player.
Tank u in advance.

[email protected]