Visonik amps turn on into protection mode(where green not red for three days)...switched over the wires to some sony amps and they dont even turn the hell on

Yeah so the visonik turned on and then later down the road stopped working right and the damn sony amps dont even turn on at all..i had the sony amps in the car before the visoniks and they worked fine...then visoniks worked fine and now nothing at all will work. im thinking something with power supply but the visoniks turn on just they turn on it safe mode.

1 Answer

Anonymous

Level 2:

An expert who has achieved level 2 by getting 100 points

Hot-Shot:

An expert who has answered 20 questions.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.
Expert
68 Answers

The fuze could be blown on the amp or the speakers are to much power for the amp at full power so try to turn the amp to half and not to turn the speakers all the way up,.

Posted on Nov 27, 2008

Add Your Answer

Upload

Upload an image from your computer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

Loading...

Include an image. It's worth a thousand words.

prev next

Related Questions:

0helpful

1answer

I have a memphis srz1 500 mono amp plaid for three day went into prtction mode on a pair of 10 incn limit edition audiobahn speakers 300 mxWas beat ive turn the amp down rewired everything with 8gauge wire...

Replace your product if seller provide you a warranty.

Read full answer

Mar 14, 2014 • Car Audio & Video

0helpful

1answer

My amp was working good and i didnt use like for two months and know it doesnt work the green light turns on but the red light too of over current and i cant hear nothing i dont know what is it..

if it turns red its a protection light you most likely got the ohms wired wrong on the speakers and the amp is going into protect mode so you dont fry it or the subs

Read full answer

Mar 04, 2011 • Sony XM-2150GSX Car Audio Amplifier

0helpful

1answer

My visonik v700hc keeps going into protect modeafter listening for a couple minuits then will go green light then back to red after a coupke more any solutions

I suggest checking what ohm load you're presenting to that amp. go to www.the12volt.com and find the subwoofer wiring diagram and choosing the amount of subs you have on it and then the impedence of each one. you're probably sending too low of an ohm load to the amp this would cause it to go into protection quite frequently and eventually stay in protection.

Read full answer

May 30, 2010 • Visonik V700HC Car Audio Amplifier

0helpful

1answer

Green light (protection mode) on, NO red light (ready)

double check your wires aren't shorting out or power or remote wires aren't grounding. check if speakers are blown with nine volt battery

Read full answer

Sep 05, 2009 • Kenwood Car Audio & Video

0helpful

1answer

Power Protection Light Will Not Switch Back to Green

Disconnect all speakers, then turn the amp on. If there is no internal problem with the amp, it will go green. If it does go green, reconnect your speakers one at a time with the amp off then turn it on. when you connect the speaker that's causing the problem, the amp will go into protection. At this point, it's one of two things, a bad speaker wire (screw thru it or touching another terminal) or a bad speaker(burnt voice coil) to test that wire, disconnect the wire at the speaker and turn on the amp, if it's still green, all's well in the wire department. Meter the speaker with a multimeter on resistance, if it's blown the meter will read 1.... If you don't have a meter, connect the speaker that's having the problem to the other channel and test again, if it goes into protection, you've got your answer. Bad speaker. Hope this helps

Read full answer

Apr 14, 2009 • Sony Xplod XM-554ZR Car Audio Amplifier

0helpful

1answer

Amps Power and Protect LEDs Both on But No Sound

its fried

Read full answer

Mar 07, 2009 • Visonik Dual Bass Box with Amplifier Car...

0helpful

1answer

Thumping speakers - no power light is on - wired correctly

the amp is going into protect mode due to something wrong in the amp or some thing in the wiring to it ooh yea if you are getting 18v power to the amp that is way to high it should not be higher then 15v if the amp is in protect mode it will not play at all.

Read full answer

Nov 02, 2008 • Visonik Dual Bass Box with Amplifier Car...

0helpful

1answer

Amp Power light will not go on. Protection light is lit- Thump sound in speakers

It probably has shorted output transistors. To eliminate other possible causes, read through the following page.

Amplifier in Protect Mode - Troubleshooting

Let me know if you have any other questions.

Read full answer

Oct 31, 2008 • Visonik Dual Bass Box with Amplifier Car...

0helpful

2answers

My Power Protector Light wont turn Green

switch off the amp then take off all the wires off including the speaker wire and then reconnect the wires on like before the problem is that the amp is on protection and if that dont work then get it repaired another thing is make sure ur amp fuses havent blown.

Read full answer

Nov 04, 2006 • Sony Xplod XM-554ZR Car Audio Amplifier

0helpful

1answer

Amp problems

It's fried. Repair costs are more than the amp is worth. Sorry, it's a lost cause.

Read full answer

Oct 19, 2006 • Visonik V117SX Car Audio Amplifier

Not finding what you are looking for?

View Most Popular

(XA1000) Car Audio Amplifier

Car Audio & Video

I have a memphis srz1 500 mono amp plaid for three day went into prtction mode on a pair of 10 incn limit edition audiobahn speakers 300 mxWas beat ive turn the amp down rewired everything with 8gauge wire...

Car Audio & Video

Open Questions:

0answers

i have a 4 ohm sub and need to make my eclipse xa1000 a 4 ohm amp every time i turn my radio up it starts cliping and cuts out

Read full answer

Be the first to answer Dec 27, 2011 • Eclipse (XA1000) Car Audio Amplifier

0answers

Pairing my eclipse bluetooth Having problem pairing my eclipse hands-free bluetooth with my verizon blackberry curve 8330?

Read full answer

Be the first to answer Oct 23, 2008 • Eclipse (XA1000) Car Audio Amplifier

433 views

Ask a Question

Usually answered in minutes!

Are you an Eclipse Car Audio and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Have a manual for Eclipse (XA1000) Car Audio Amplifier? Or just drag it here!

Related Topics:

Visonik amps turn on into protection mode(where green not red for three days)...switched over the wires to some sony amps and they dont even turn the hell on