How much watts is the phoenix golp xs4300 amplifier

XS4300 SPECIFICATIONS:
Output Power: 4 ohm stereo @ 12/13.8 VDC 12/35 WRMS x 4 2 ohm stereo @ 13.8 VDC 75 WRMS x 4 4 ohm bridged @ 13.8 VDC 150 WRMS x 2 Crossover Frequencies 20Hz to 20kHz(Rnet factory set at 100Hz) Crossover Slopes 24dB per Octave

Do you no the continus whate rateing of it? End i don,t mean peak or maximiun Watts on it, All so the RMS) watts that the sub will handle,

into 4 ohm 13.8 volts 160 watts rms x2 2 ohm 13.8 volts 255 watts rms x2bridged 4 ohm 13.8 volts 510 rms
hope that helps or follow link to manual
http://download.phoenixphorum.com/Manuals/Amplifiers/MS_MAC_Amps/ms2125.pdf

i checked all around the internet for that am and its a discontinued product as far as I know. i have found some for sale on craigslist but within no time they were sold even on ebay. but the main sites dont have it cause it maybe discontinued

http://download.phoenixphorum.com/Manuals/Amplifiers/XS/xs4chan.pdf

I have the following specs for you
Basically 150watts per channel using two channels , or 75watts using all four
Here goes:

• 4 Channel Mosfet Amplifier
• Advanced Overload and Thermal Protection
• Metal Film Capacitors/Resistors In Signal Path
• Frequency Response +/-1dB, 20Hz to 20 kHZ
• Signal to Noise Ratio (A-weighted) >100dB
• Max Continuous Bridged Power @ 1% THD 150 watts x 2 into 4 ohms @ 14.4 Vdc
• Max Continuous Power per Channel @ 1% THD 75 watts x 4 into 2 ohms @ 14.4 Vdc
• Nominal Continuous Power per Channel @ 1 % THD 35 Watts x 4 into 4 ohms @ 14.4 Vdc
• IASCA/USAC Power Rating 12 Watts x 4 into 4 ohms @ 12.5 Vdc
• Minimum Load when Bridged 2 Ohms
• Minimum Load per Channel 1 Ohm
• Input Signal Voltage Range 0.1 volts to 2 volts
• Crossover Type Resisitor Network, Linkwitz Riley,
• Highpass/Lowpass
• Crossover Slope 24 dB per octave
• Crossover Frequency Range 20-550Hz
• Factory Crossover Setting 85 Hz
• Auxilary Output Channels 2
• Auxilary Output Frequency Range Highpass or Lowpass, Opposite of Speaker Output
• Bass Boost 0- to +18dB @ 45 hZ
• Power Supply Voltage 10Vdc to 15.5Vdc
• Recommended Fuse 40 amp

Dimensions 12.25L x 9.25W x 2.10H

Normally the numbers give you a big hint. 2180 means this is a 2 CHANNEL AMP EACH CHANNEL CAN PRODUCE 180 WATTS OR 360 WATTS BRIDGED.

It's "Clean" power is 75 x 2 at 4ohms
and 125 x 2 at 2ohms
Bridged mono it's 300 clean.

how many watts is the amp and speker are you sure you are not putting too much?

Owner's manual


Page 14.