I cleaned the air filter as the manual instructed, and put everything back together. I reset the red light. Now my unit will not turn on at all. This was the first time I cleaned it since I got it.
SOURCE: Kaz Honeywell Tower Air filter rest light
When the filter monitor light remains on, it is time to check/clean the IFD™ filters and reset the filter
monitor, if needed. With the unit powered on, insert the tip of a ball-point pen or paperclip next to the LED
filter check light and hold for approximately 5 seconds until the light turns off (Fig. 3). Depending upon
your individual usage (environment and hours used), you may need to check and clean the filters more or
less frequently. If the IFD™ filters are cleaned before the filter monitor light turns on, the filter monitor
should be reset at the same time.
SOURCE: reset filter
The solution is simple. Just press on the little red light that says to reset filter. Its a button that will reset the warning and the light should go out
SOURCE: Honeywell HFD-135 -- lost instructions -- how do i clean removable filter?
Manual can be found here: http://www.kaz.com/kaz/support/manual/?ProductManualAction=renderProductManualById&ProductManualId=47a366c04a65e77c69850893b979e142
SOURCE: I had a honeywell hepa
http://www.honeywellpurifiers.com/ssi/pdf/honeywell/50100-200-300-manual.pdf The Intelli-Check™ Filter Monitors will indicate replacement of the pre-filter and the HEPA filter. Depending upon your individual usage (environment and hours used), you may need to check and replace the filters more or less frequently. To check Expected Filter Life Usage When the unit is turned on, quickly press the appropriate filter monitor button. The pre-filter light will flash up to 3 times and the HEPA filter light will flash up to 4 times, depending upon how much expected filter life has been used. PREFILTER: 1 flash = from new, up to 1/3 expected life used up 2 flashes = between 1/3 and 2/3 expected life used up 3 flashes = between 2/3 and all of expected life used up Remains on = time to check/replace pre-filter HEPA FILTER: 1 flash = from new, up to 1/4 expected life used up 2 flashes = between 1/4 and 1/2 expected life used up 3 flashes = between 1/2 and 3/4 expected life used up 4 flashes = between 3/4 and all of expected life used up Remains on = time to check/replace HEPA filter To RESET Filter Monitor When the filter monitor light remains on, it is time to check/replace the filter and reset the filter monitor, if needed. With the unit powered on, press and hold the appropriate filter monitor button down for approximately 5 seconds until the light turns off.
Depending upon your individual usage (environment and hours
Page 6:
3,470 views
Usually answered in minutes!
×