Error code i've changed a toner bottle of ir2000 and then it displayed system error e001 what i can do for solving this problem?

Abnormal rise in temperature and humidity

Dear
Its related to the fixing temp. do the error clear on service mode. then check the fixing film assy. heater circuit contact points for corrosion. Replace it.
Thanks.

Code Error name/description

E000 fixing overheating

E001 fixing assembly overheating

E002 fixing assembly low temperature

E003 post-standby fixing low temperature

E007 fixing film rotation error

E010 main motor rotation error

E014 fixing motor rotation error

E019 waste toner case full, waste toner case full sensor error

E020 toner clogging between sub hopper and developing assembly

E024 developing assembly connector disconnection

E025 hopper motor, bottle motor error

E032 NE controller counter error

E064 power supply voltage error (high-voltage)

E100 BD interval error

E110 scanner motor error

E191 communication error for high voltage power supply

E202 CIS home position detection error

E225 CIS light intensity error

E227 reader unit power supply error

E248 backup memory error

E261 zero-cross signal error

E315 image data error
E400 feeder communication error

Hi,
can You be specific by mean of which system error? Like E100? E000?, E001....

Few examples of most common errors:
E100 - Laser trouble - change the drum unit ( complete drum unit )
E000/001 - fixing trouble - try to reset the error under service mode - procedure: press MENU and #, with > key go to CLEAR and OK, find ERR and OK, turn off and back on - if it helps you solved the problem, if not you need to change the thermistors or the fixing lamp, because you have low/high temperature problem.
E019 - waste toner full - remove the drum unit and open the corks on top of the unit and empty/vacume waste toner out.

Hope that helps!

C2558: Abnormally high toner density detected black TCR sensor
Reinstall imaging unit
Reinstall toner cartridge
Change imaging unit/K
Change PRCB

mixing toner canon ir2000

Power off the machine and gentlly take out the toner bottle. Then with the bottle out turn on the machine let the machine go thur its normal routine when the indicator comes on for toner install toner bottle. If the code comes back you have a problem with the Toner Bottle motor, gear, or Main Board.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

wich system error?Is it 001, E100, E019?

Did you reset the error after replacing the fixing?