My right front turn signal wont work, the dash board light came on telling me i need a new bulb i put one in and it still does'nt work . I checkd all fuses and they are good , me right rear turn l

was the correct bulb used? this sounds like a single function bulb was used NOT the bulb that will light with the headlights and ALso produce turn singles

I don't believe it would be a bad ground for just one light. It could be a wire, a socket connector, or the bulb socket itself. See if the wire has power at the socket when signaling left, with key on. If there is power, probably a bad socket or connector. If no power, check for power coming from flasher-the wire going to front left, or driver's side. If you have power from the flasher, but nothing at the socket, the wire has probably broken.
Good luck.

Hey I literally just today had the same problem, put a new bulb in the light was on but did not blink!!!! SUPER EASY SOLUTION, you simply have the bulb in too far. I gently pulled mine out a tiny bit and it started working fine... guarantee that's all that's happening to you!!!

If the indicators on the dash are staying lit all the time, it is because you likely have a bad ground to one of your running lights, causing the running lights to ground through the turn signal circuits. This is often caused by either a bad socket assembly at one of the bulbs or an incorrect bulb is installed in one of the sockets. You need to check FRONT and REAR lights to see which one is not working correctly. Also check the running lights and marker lights on BOTH sides of the vehicle. There will be SOMETHING that will not look the same from one side to the other if the left side is working correctly and the right side is not. Please keep in mind that you cannot use the right REAR turn signal without also using the right FRONT turn signal. The problem could be at EITHER end.

Your right rear turn signal bulb is blown.Replace the bulb and the fast blinking will stop.

First, is it doing it on BOTH isdes or just on one side? Example: turn signnals flash OK when turning left, but only come on and stay on when turning right. If it is doing this, then you most likely have either a blown bulb or a bad bulb socket on the side that is not flashing. You need to check both the FRONT and REAR bulbs to make sure they are all functioning properly.
If it is doing it on BOTH sides, then you either have a bad flasher, or at least 2 bulbs burned out (one or more on each side).

Are you sure you replaced the correct flasher? The flasher for the HAZZARD lights is plugged into the convinience center under the left side of the dash. If this is the flasher you replaced, it is the wrong one.
The turn signal flasher is mounted to the driver's knee bolster bar near the steering column. It is held to the bar with a clip. (see diagram)

common on olds make sure single contact bulbs & dobble contacts are in correct spots
and problem is in the front signals connecters remove bulbs and ull see burnt plastic
replace or clean

IT IS MOST LIKLEY A FLASHER PROBLEM CHECK MANUAL AND FIND RIGHT ONE. AISO MAKE SURE BILB IS NOT BAD IVE SEEN THEM LOOK FINE BUT ARE'NT.ALSO MAKE SURE NO GREEN COROSION IS PRESENT AT BULB PLUG IN. 7 UP WORKS GREAT TO GET RID OF IT ...RINSE WITH WATER WITH OUT NO POWER TO LIGHTS....GOOD LUCK A.S.E. CIRTIFIED B.HARRIS 25YRS EXP

most likely its your muti-funtion switch in the steering column.but first check your turn signal flasher & your emergency flasher

the fuse is broke