Woke up turned the system on and have no sound

devise settings are not matched with each other

Make sure you are on the correct av channel. Av2 and not Av2s

I put the recorder channel on AV2 and then recorded it. It worked. Thank you anyway.

Look at the rear of the TV/VCR/DVD & you will see long black sockets where the Scart cable is connected onto, these are normally indicated as AV1/2 etc. You can then take Scart from DVD to TV on AV1. Then on AV2 take the second scart from VCR to TV or you can take the second scart from the DVD to the VCR & from the VCR to AV2 on the TV.

if you connect the dvd to the tv using scart socket 2 (av2) it should send a signal to the dvd, depending on the make/model of tv, you also may have to set the av2 output in the menu.
Alternativly, connect the sky to the dvd input and the dvd output to the tv, this should also work.May have to watch the tv with the dvd on set to av.

You won`t get round the scan without an aerial.You still can set a recording as long as you set the recording channel as av2.Make sure the scart lead is fully in on dvd and tv,this can lead to no pic but sound,or sound no pic

Most TV's send a signal out using Scart 2(AV2 on remote). So connect a scart to AV2 and to the AVin on the recorder, set the timer or manually record using the AVin as the channel. Unfortunatly you cannot use video plus as this would set to record from a normal channel. As I am not familier with the make of your tv, it's not a guaranteed solution, but I am 80% sure there is a way of sending the DTV signal out through one of the scart sockets.

the two AV1 and AV2 have different inputs on the IC,
the first port has a disconnection,
take your tv for a check up

My phillips tv model # 55pl9773/17 sound is too low when im watching regular tv, but when i switch from tv to av1 or av2 (watching a dvd movie or playing video games) the sound is normal. How do i get my cable TV to sound the same?