Change time How do I change the time on the KX-T7736 Panasonic Phone?

If you have a Panasonic KX-T7736 phone with one line not producing dial tone, there are a few possible causes. The first possibility is that the phone line itself is the problem.

If you have another phone in the house, try plugging it into the same phone line and see if you get a dial tone. If you do, then the problem is with the KX-T7736 and not the phone line.

The second possibility is that the problem is with the phone's internal wiring. To check this, unplug the phone from the wall jack and plug it into a different jack. If you get a dial tone, then the problem is with the first jack and not the phone.

The third possibility is that the problem is with the phone itself. If you've tried the other two solutions and you still don't have a dial tone, then the problem is most likely with the KX-T7736 and you'll need to contact Panasonic for assistance.
I hope this helps!

You may download the manual from http://www.retrevo.com/support/Panasonic-KX-T7736-Telephones-manual/id/2878ag022/t/2/

The time can be set through system admin programming at an extension that has been allowed this ability, usually the attendant phone. To access system admin programming press <program> **1234(1234 is the default password). Once in programming dial 000 for time/date. Use the LCD navigation keys or the jog dial to scroll through the date to get to the time, after setting the time press <enter> to save the new time then lift handset to end programming session.

Yes.

I've found the operating instructions for the KX-TGA641T cordless phone instead, but, unfortunately, KX-TGA614, as you have typed in, doesn't seem to exist at Panasonic's support page. Hope you have mistyped your phone model, and that this one might suit your needs,
Regards, Caroos

Unless I missed my guess, try pressing the * key while the phone is idle.

Carl

I am not sure exactly about this phone, I am thinking there should be an info button or soft key under the LCD that will cycle through the ext name, date/time/mode. If there is not let me know.

I believe you push the CO button, of the call you want to keep! (you have to remember which call is which!!

This is just the quick answer and may not be exact. System program 203 is the intercept time. It's probably set by default to 40 seconds. A ring cycle is about 6 seconds. Try adjusting that down to, say, 20 seconds and see if that works. I have your exact setup in my office, but I'm not in my office for the rest of today. I may get a chance to play with the timing on Saturday.

Carl