Bowing and ghosting

Your convergence ICs are bad, plus possibly a few resistors

I’m happy to help further over the phone at https://www.6ya.com/expert/eric_ab7c09ec01841771

ok meoff check the convergence circuit. shadow in the picture is defective convergence circuit... replace a new.

you need remplace 2 parties-- stk-392-560, 12 bucks each

what type of tv do you have. sounds like a loss of covergence. if its

Go to Menu then setup look for convergence if you do not see convergence on menu then you have a open FUSE FL231 it is on right side of FBT flyback transfomer there is 3 of them small brown rectrangler looking caps it will be the one in the Middle.

This happened a few years ago to me. I called the repairman out and he said that I had my tv too close to a magnet source, which turned out to be a speaker and also the reciever for my home theater. See if this may be your problem. Good Luck.

The STKs are common and if you have an experienced electronics tech around they can replace them for much less money but the tech must have advanced soldering and IC exchange experience.

The STK ics, two of them, can be purchased on line for around $20 to $40 each.

http://www.partstore.com/GetModel.aspx?MfgName=Toshiba&BrandName=Toshiba&ModelNu...

Partstore has two models available - one for around $40 and another for around $55.

The part number is STK392-110 and if you google you can find them for as little as $6/each but I don't recommend the cheap ones as they are not reliable.

It takes a good tech around 3 or 3 hours to take the old ones out and solder in the new ones. Also, it is likely one or two resistors are burnt and will need replacing as well.
· http://home.earthlink.net/~oleg.filippov/ConvergenceFix.htm
· http://cmpalmer.blogspot.com/2006/11/fixing-my-own-tv-part-ii.html

KIT10 $29.50
Repair Kit for Hitachi convergence Chassis DP-14G
KIT10 Includes 2 pcs STK392-150 , 1 each of the following 1W axial lead fusible resistors:


http://www.digitalhome.ca/forum/showpost.php?p=564268&postcount=220
http://cmpalmer.blogspot.com/2006/11/fixing-my-own-tv-part-ii.html

The two convergence IC's part# STK392-570 need to be replaced - about a $300-$400 repair.

Replace convergence IC's--then re-check convergence alignment in servicer mode,if necessary.