Radio reset when i turn off the car the radio resets helllllllllllp

To reset the Uniden GMR1938-2 radio and turn off monitor mode, you can follow these steps:
1. Turn off the radio by pressing and holding the Power/Menu button until the unit powers down.
2. Once the radio is turned off, press and hold the Menu button.
3. While holding the Menu button, turn on the radio by pressing the Power/Menu button. Keep holding the Menu button until the display shows the Reset prompt.
4. Use the Channel Up or Channel Down button to navigate to the Reset option.
5. Press the Menu button to select the Reset option.
6. The display will show a confirmation message asking if you want to reset the radio. Use the Channel Up or Channel Down button to select "Yes" and press the Menu button to confirm.
7. The radio will reset to its factory default settings, including turning off the monitor mode.
After performing the reset, the monitor mode should be turned off on your Uniden GMR1938-2 radio. You can now use the radio normally without the monitor function active.

The 2015 Nissan Altima does not have a mute button for the Audio system. To unmute the Audio system You will have to turn the volume knob clockwise. If this does not fix the problems with the Audio in the vehicle You can try and attempt a full reset of the radio in Your car. To do this You will turn the ignition key to the "on" position and turn Your radio on, wait ten seconds and then turn Your radio off. Depress the radio power button again and wait for reset. Alternatively, enter Your dealer provided radio code to reset. You can also check to see if You had a call and if You did not press the "call hang up" button on the steering wheel while not on a call it could mute the radio so press it again to un mute it.

what you may do is....turn the car off and then turn the radio on.. don't do anything with the car for one hour. meaning leave the radio on for one full hour and the radio itself will reset itself. the radio will turn off.turn the radio on..on the radio it will say... BOSE..press and hold both button RDS and FM2 until the radio resets to 0000 ..then enter in your code..once you enter your code press and hold the two buttons again..this will work...

try 00000 or 000000 or 0000

or

Find a unlock code at free of cost in this site http://www.unlock-free.com/samsung/

Turn the radio off and disconnect the battery for 1 min. After reconnecting he battery, turn on the radio and that should have reset the radio. Good luck and just make sure you turn off the radio first.

if you have the anti theft code for your radio (if its stock) disconnect your negative battery terminal for 30 minutes.....reconnect and enjoy....did you use a reset tool or did you jump the diagnostic pins to reset?

soft reset. get in turn on truck with door shut turn on sat radio on ch 184. turn off radio turn off truck and take keys out. next open door fully for 90 seconds. shut door. turn on truck. turn on radio and have sirius reset it. its called a soft reset.

check the consumer reports best buy online, they usually can tell you something about vehicles and issues they have had. Daewoo has NOT been on the market that long really. I would look more at some other brand vehicle that's been on the market alot longer to be honest.

If you made 2 errors, the radio will locks up. You could pull out the radio for several day, or months, but never will reset this hard SAFE.
The solution is easier than you are thinking; "Just turn on the radio, and turn on the switch key, but don't run the car. Leave ON the car switch and ON the radio for one hour".
After it, you will be able to use your unlock code. (Holding Mode+Scan until SAFE change to 1000... )
Remember... you have just 2 oportunities to enter the right code

Hi
Uninstall the software. Make sure no software fragments are left, then reload the software. Ensure that you install to the manufacturer's instructions. I had this problem and it took several times of uninstall and reinstall, but! eventually it worked, much to my relief.