Im looking for a really light weight **** scoop

2.7 pounds, NO

darn tootin!!!!!!!!!!!!!! im using it and im losing weight!!!

It depends on the density of the powder. Cubic centimeter (cc) is a measure of volume while pound (lb) is a measure of weight.

15 pounds of water occupies about 6800 cc, while 15 pounds of gold occupies about 500 cc.

you're comparing volume and weight. If you mean water than it's a lot. 1cc = 1ml. 1ml of water weighs 1g. 15lbs = 6803g. 6803/50 = 136

136 50cc scoops of water will weigh 15lbs

That's umm. Really great..

A scoop barstool is a barstool that is not your conventionalflat bottomed stool. Regular barstoolsare normally made out of wood. Scoopbarstools are generally made of fiberglass and are backless. They are called "scoop" because there is anindentation in the seat to make it more comfortable to sit on. The seat, itself, sort of looks like anice-cream scoop. They also tend toswivel as opposed to being stationary like most barstools.

Hi
Plz try this link:
http://www.breville.com.au/
Hope it works if not plz specify the model no of the product to get the specific manual.

Thanx

Hi. A typical soda fountain-style ice cream scoop--a #8 food portioning scoop--holds 1/2 cup of ice cream. One gallon is equal to 16 cups, so there are 32 scoops of ice cream in a one-gallon container. Each scoop should weigh 4 ounces. A strong handed scooper can put an ice cream shop into bankruptcy so ALWAYS weigh each and every scoop.

With soft serve, one gallon of mix makes 36 - 4 ounce cones. Once again weighting the cones is key.

The hot dog vs hamburg ? depends totally on the sizes, the toppings and the type of roll used. Experiment there but start out with hot dogs to keep it simple. Regarding chips and fries, once again chips are simple with little waste, cold fries often go in the trash. Good luck. J.

I think the reason is sliding it up too hard. I've looked at it and done some experiments and i found that sliding it up too hard can damage the LCD screen and it will occasionally shut down without notice. So i'm assuming sliding it too hard is the main reason.

you mean 1988..??.. ok.. yes a good fiberglass man could help and fix this..and then repaint to EXACT match so you can pass whatever you need to pass...