Light flashes green than a code E06 and E01 comes on than tv off

E01 and e06 codes - Fixya

www.fixya.com/support/t14040885-e01_e06_codes
Aug 19, 2012 - e01 and e06 codes washer will not do anything other than lock the door. - Whirlpool Duet: WFW94HEXW Laundry : question. ... Error message E06 onWhirlpool. Unplug the machine and wait 10 minutes before restarting it.

Try this solution I found on a German site. Other sites I found did not even mention E06 as possible. Site is linked below, you can use GoogleTranslate to convert to your own language. Good luck!

Error E06 Canon MP287

The characteristics or signs:

• Currently in turn on the printer does not print the worksheets.
• ALARM indicator light lit In follow with lights flashing orange ink information.
• LED indicators display appears on E06

How to Reset Error E06:

• Press and hold the stop / reset until the standby light green and then release.
• If the indicator light still flashing again, repeat again by pressing the stop / reset.
• Finished

Dunia Printer

If you wish to get some details, check the site linked here. Pull up older posts. Check the site in 'Mosaic' view. It will make search easy. http://electronicshelponline.blogspot.com/ Error code details to many brand TVs are given.

Hello,
E06
---
Paper output cover is open. Close the paper output cover.

Hello
Power regulator board inside it has damaged. In most cases, this board is irreparable due to unavailablity of components. Replace the board as card basis. Especially plasma TV boards are very complicated in circuit nature, and cannot be repaire without getting proper components. No substitutions will go on with these power supplies. So replace the power supply board with same type and number. You can get it from Authorised Service Center for Sharp at your town. OK.

This is directly from the manual

Page E-66
E 01 = System cable connection
System cables are not properly connected. Check that all system cables are connected properly.

See page 12.


http://sharp-indonesia.com/manual/Plasma%20Display%20Panel%20%28PDP%29/PZ-50HV2,%20PZ-43HV2,%20PZ-MR2M,%20PZ-MR2X/pz50hv2x_au.pdf

http://sharp-indonesia.com/manual/Plasma%20Display%20Panel%20(PDP)/PZ-50HV2,%20PZ-43HV2,%20PZ-MR2M,%20PZ-MR2X/pz50hv2x_au.pdf

Mike - I've got the same model with the same problem. Did you ever figure it out??

Cincinnati Joe

well first of all i have to assume that this tub is equipped with jet's on the floor and lights,if not then there's no reason for it those buttons to light up, now if it is equipped with these features and your getting a error code all this means is that this tub need to Re Configured to run this type of system,this is something a tech needs to look at because you wouldn't be getting error codes if the tub was configured wrong the reason your getting error codes is because something isn't plugged in correctly at the control box and the computer detected a fault.
Justin 503-547-3483

What does this control look like? Can you email us a photo of the control?
usually that error code is a water level problem.