Zanussi Turbodry 1200 spin problem

You should be able to get one from zanussi by going on to there website

its very common for front load washers to have the water pump to freeze up.

ever washed something with sand or little rocks or rubber bands?

flip the washer to the side, then locate the water pump. take the filter and the hoses around the water pump. sometimes the water pump too, to make sure that the fins on the water pump are free and not stuck. put everything together and try the cycle. when the water pump is stuck it will cause the error and will not go into the spin cycle.

Hello,

Have you fixed the problem yet? And if yes, how??
I have the same washing machine with the same problem. So I hope you can help me!

Best regards,

Nourah van Leeuwen

its the doorcatch,turn power off, remove lid and put hand in machine where doorlock is situated feel about and try open catch, repair or replace?

CLICK HERE



Please download asap - as it is stored on my personal FTP site, and will be removed in 48 hours.

Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question

E40 indicates the doors not closed properly. Sometimes it can be the lock itself or the main control board

clean out filter, door bottom right, unscrew filter and clean it

possibly a foreign object in pump.
tilt backwards at a good angle and remove pump. i find the easiest way to do this is to undo the 3 screws round the periphery of the pump

Either clip on the door is faulty or its the door interlock in which the door locks into easily replaced by undoing the clip pullling back the door rubber and replacing ..

It appears that you may have a faulty door interlock or a faulty PCB. pcb is not really a DIY job as some boards require proramming on certain versions. Regards Advisor