- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
You would have to try an INIT and see if it causes the tv to be operational again. It is something that you have to be walked through step by step by step and can erase the memory of the tv if done improperly. Call Sharp tomorrow morning at 9AM CST and someone can walk you through one. Call 800-237-5277 or if you have an aquos advantage model call 87-332-7867
The walking belt slows when walked on the walking belt maybe overtightened, treadmill performance may decrease and the walking belt may become damaged or the opposite the drive and /or running belt may need tightening. Last thing would be that the belt needs lubrication to be applied between belt and deck.
Fault at its main digital board. Short circuited component/s at it. Contact any service technician; or the authorized service center. If you wish to get some details; check the site linked here. Pull up older posts. http://electronicshelponline.blogspot.com/
In most cases, the main board might have to be replaced. If so, a software [firmware] update too might be necessary.
Here's an oddball, but if you have some thing similar, hopefully helpful. The problem turned out to be the focus anode (coming out of the flyback, going to the focus block) had broken loose enough to start arcing inside the flyback. Gently pulling the wire out of the flyback, clipping, stripping and tinning the end, and gently pushing the tinned lead back in until it locked proved to be the answer.
Now I am not a expert in this field by any means and there may be someone else that can give you a better answer but I will provide some insight from experience. When this happens it is usually do to the television going into protection mode, this is to let you know something is wrong inside the T.V., it does this to prevent any further damage to the T.V.. I do not know but if it is still under warranty you should read your warranty paperwork and contact whoever it tells you to, if it;s not then you should contact your nearest T.V. repair shop.
hope this helps
I have studied the internet with your problem for about 5 hours and find that 75% vote for replacement rather than repair, but it can be fixed for some time and some for quite some time. I am choosing to replace after I find someone who can walk me through the on-screen diagnosis, (just for fun). Jimmy Wayne