Question about Panasonic PT-51G63 51" Rear Projection Television
I had this model where it would come up in standby but would shut down straight away....and led on front will would blink twice.....found the blue tube arching
Posted on Aug 07, 2008
The reason for this is excessive ht. The b+ is 139 volts however when you monitor this on brief start up the b+ goes above 150 volts. therefore it fires the protection circuit. Begin by checking the 2 capacitors in the hot side of the power supply module for low capacitance , then check both 33 k 2 watt resistors for high value. If all proves ok also replace se 139 and strm6833b.
Posted on Jul 07, 2008
Did you every get a solution to your problem?
Posted on Dec 28, 2007
456 views
Usually answered in minutes!
Hi, I have the same issue, no picture or sound, but the red "on" light stays on for a few secs. thank you in advance.
I CAN ONLY EAR THE RELAY "CLICK" BUT NOTHING ELSE HAPPENS
when turning on there are 2 red light indicator but no picture or sound. no light on fillament tubes.
I NEAD A CODE PANASONIC PROJECTION TV MODEL NO HOW I CAN RECIVE.
standby light flashing television not working
×