Kenmore oasis electric dryer beeps and displays code F45

The CF error is a communication failure between the main computer and the touch panel...you may have a bad or weak connection or a bad computer..I wold recommend that you contact your local Sears and ask them about recalls, and for service should this happen again.

Hi Celine, I just experienced the same exact problem. I came here looking for a solution. I got mine to stop by holding down the cycle signal button for 3 seconds, releasing it for three seconds, and repeating until both lights (loud and soft) went off. Hope it helps.

peter

This symptom indicates a stuck key on the user interface control board.
Replacing this control board would most likely fix this type of problem.


You can order this part from SearsPartsDirect.com, RepairClinic.com, PartSelect.com etc.



Before buying any parts I suggest you access the interface ribbon and disconnect it and then connect it back and see if there is any improvement.


You might also remove the interface from the console and check the console for any stuck buttons.

Remember to unplug the unit first.


Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question

3 Beeps/E30--Error: Drum overfilled. Cause: Inlet valve,pressure switch or control board failure.Select drain/spin to remove water. Restart.



Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question

repl user interface ,, it has a stuck button,, order inter face

possible stuck button on inter face ,, this sounds like kenmore oasis dryer

The user interface button panel has failed and will need to be replaced.

please give model and the make

MY WASHER IS BEEPING EVEN WHEN NOT IS USE.

That would the user interface board (touch panel)behind the dash. Sorry, but not a cheap fix at all. Maybe search Ebay for the part, sometimes you can find it cheaper. Very expensive part and repair. Good Luck to you. Jim