Service error code 6000 for canon pixma ip 1500
Anon PIXMA iP1000
Waste Ink Counter Reset.
Step 1: Manual for Service mode
1. Unplug power and USB.
2. Open door and hold power button.
3. Connect power.
4. Close door, then release power button.
step 2 : Software for Permanant
1. Reconnect the printer cable.
2.Open General Tools software and select (USB PORT)
3 .Choose (SET DESTINATION 1) And it should be reset.
Remark "After service mode Pls use software for permanent reset"
Posted on Jan 18, 2008
I had the same problem but the reset did not work. Any other suggestions please would be appreciated.
Posted on Dec 28, 2007
Hello Surs, Wish I could be more confident of this but I couldn?t find much on this series of printer. You didn?t indicate if there were any LED codes being flashed but this is the only reference I could find involving ?6000? and this model printer. Issue: Power light (or Alarm / Power lights) alternate(s) between orange and green 3 times (6000) ________________________________________ Solution: Reset the printer Follow these steps to reset the printer: 1. Turn the printer off with the Power button (if available). 2. Disconnect the data cable from the printer (not applicable to WiFi, Bluetooth or Infrared) . 3. Unplug the printer's power cord for a few seconds, and then plug it back in. If troubleshooting a communication issue, reconnect the data cable (not applicable to WiFi, Bluetooth or Infrared). 4. Turn the printer back on. I don?t have a service manual for this printer nor was I able to find one anywhere. From poking around the Canon site it appears that there are other error codes than what is published in their manual or web site so it might be worth a call to the help desk. Let us know if you have any more questions or information and don?t forget to rate the post.
Posted on Jan 05, 2007
3,280 views
Usually answered in minutes!
printer is set for color but only prints black @ white
my waste ink aborber is full what sould i do
service error 6000.....
the ink tank is hiden in the corner, the LED blinking green and orange.
1. fromhttp://www.geocities.com/uki_mrit/Cover....
press the resume button all the time, than unpluged the power cable, release the resume button. connect power cable, and then turn on the printer.
the ink tank back to it position, and I can refill the ink....the LED stay green....i do reset ink in the maintenance, because ink tank was refill.....after that i print two test page.....woow I success....I turn off the pixma....and turn it on again the next day.....woow error 6000 again....I think I will take it to the canon service.... I had enough.....any ide???
Service error code 5200 for canon pixma ip 1000.
What can I do?
mine is canon pixma ip1980 printer that has service error 6000 also!
Canon PIXMA MP250 error code P22
Canon PIXMA MP250 error code P22
service error 5c20
error 6000
×