Question about Disney DTD1363-CAR 13" TV/DVD
I can not connect my little leaps to my emerson dvd/vcr combo
I went to the Little Leaps website and went into customer support and viewed a link that provided additional codes. I have the Emerson dvd player with video cassette recorder EWD2203 and the code 027 which was listed in the additional codes at Little Leaps website worked for me.
Here is that list of additional codes from the Little Leaps website:
018,030,035,005,150,151,043,058,011,147,148,016,004,002,144,007,009,146,013,020,027,133,042,129, and 149.
These codes were listed to try with any players.
Posted on Nov 18, 2008
Code 027 also worked for Emerson DVD/VCR model EWD2003
Posted on Aug 25, 2013
Tips for a great answer:
0154, 0236, 0463, 0180, 0178,
The One For All 4 Device Universal Remote Control is preprogrammed at
the factory to operate an RCA TV, a Toshiba DVD player, a Motorola cable
box, and an RCA VCR.To control devices other than the default brands,perform
the following steps; otherwise skip this section:
 Turn on a desired device (e.g.,VCR or DVD player) and, if
applicable, insert media (e.g., cassette or disc).
NOTE: Please read steps 2 through 4 completely before proceeding.
Highlight or write down the codes and device you wish to program
before starting step 2.
 On the remote control,press a device key once (i.e., VCR/PVR,
DVD, CBL/SAT,or TV).
NOTE: To program control of a VCR, PVR (or DVR),TV/VCR Combo,
or TV/VCR/DVD Player Combo press VCR/PVR once.After programming
a VCR Combo device, you will be able to control channel selection,
volume, and VCR functions.
NOTE: To program control of a DVD Player,DVD Player/VCR
Combo, or TV/DVD Player Combo, press DVD once.After programming
a DVD Combo device, you will be able to control channel selection,
volume, and DVD functions.
NOTE: To program control of a Cable Box, Cable Box/PVR (or DVR)
Combo, Satellite Receiver, or a Satellite Receiver/PVR (or DVR)
Combo, press CBL/SAT once.
 Press and hold SET until the LED (red light) blinks twice,
then release SET.
 Use the Manufacturer's Codes (starting on page 18) to
locate the type of device and brand name and then enter
the first four-digit code for your device. If performed correctly,
the LED will blink twice.
NOTE: If the LED did not blink twice, repeat steps 2 through 4 and enter
the same code again.
 Aim the remote control at the device and press POWER
once.The device should turn off. If it does not, repeat
steps 2 through 5, trying each code for your brand until
you find one that works. If it still doesn't work, try
Searching For Your Code on next
NOTE: If the device does not have a POWER key, press PLAY
Usually answered in minutes!
Step 2: Please assign your manual to a product: