Need info on how to wire a radio in a 1994 nissan pickup

Question edited for typos.

These are the D21 wiring details. The best way is to get a conversion harness D21 to JVS from Crutchfield.

1994 Nissan Hardbody Pickup Stereo Wiring - The12Volt

https://www.the12volt.com > installbay > stereodetail
1994 Nissan Hardbody Pickup car stereo wire colors, functions, and locations.

Nissan Hardbody radio wiring colors

https://forums.nicoclub.com > ... > Nissan Trucks Forum
Mar 5, 2011 - have rear wires i ran my own but this was schematic for after market plug to harness so colors should be right unless back are missing and ..

Here's the link and I'm sure you will get the solution of your problem 1986 1995 Nissan Terrano Nissan Pickup WD21 Series Workshop Repair Service...

Check the harness for any missing wires, its the main bundle of wires under the dash. If all is in place then check the fuses to see if any needs to be replaced. If all are tested and working, check the relays located in the main engine compartment. If all are intact and working, check the ground wires that connect to the frame of the engine and body or directly to the negative of the battery. The main wires you need to see that are connected is on the alternator, starter, and battery.

Hope this hepls

take the coil wire off the distribiter cap an put a spark plug in it an have someone crank it to see if its fireing.if its fireing then the coil is good.

these kind of behavior generally happens,when the tappets clearance is less than the specified .that means when the engine heats up valves elongates,and the gap reduces,resulting valve leakage,improper combustion,power drop, emission, missing etc....set the tappets

plugs?-wires?-distributor?-coils?-catalytic converter?-timing?-is this a z24i or just z24 [email protected]

You can buy a kit from a number of sources to solve this problem. Instructions come with the kit. If you are putting a stock radio back in go to a junk yard and cut the loom out of another truck and marry it to your truck. If you don't want to do either of these things the fat red wire is almost always hot. The antenna cable is unique and will only fit in one spot. the speaker wires are small diameter and will work no matter which way you hook them up as long as one hot (speaker) wire and one ground wire go to each speaker. Have fun.

Sounds Like you need all new plugs and plug wires. Change your cap and rotor while you are at it!

I owned one and i regret having to have sold it. I do not know of any ongoing problems with this vehicle. check around your clutch pedal for wires that may be rubbing against it and are grounding out or cut? you can find schematic in manual at parts store and i recommend buying one for your own good. They are a wealth of information about your vehicle.

Not for sure if I can help.Someone forgot the golden rule.NEVER CUT THE WIRING HARNESS.I dont have the wiring scematics in front of me but the older models had RED for power,BLACK for ground,and the wiring going to the spreakers should be an off color running together going to the speakers.Probably has a six speaker system.Hope I helped.