My baird tv has gone off following a power cut now the power light just flickers and it wont turn on

My baird JO47 tv is stuck on standby - Digital TV - Streaming ...

www.tomsguide.com/forum/55998-4-baird-jo47-stuck-standby

Dec 17, 2012 - 4 posts - ‎2 authors
My Baird JO47 tv is stuck on standby and won't come off. ... I have a panasonic 50" TV it will not turn on no green light or standby red light ... Forum; my tv standby light keeps flashing blue on and off and won't switch on Forum ...

Baird JO47 Stuck on Standby ' Electronics Forum (Circuits ...

hi make sure the lamp door is securely fitted has there is a safety switch, thanks

shaun

Hi Anon,
If your LCD TV or monitor has stopped working, or is displaying one of the following symptoms, then it's a candidate for some new capacitors
- Flickering screen
- Screen image disappears after several seconds
- Dim screen
- Slow start
- Power LED on, but no picture
- Unusual colors and/or lines
The primary cause of LCD TV and monitor failure is caused by faulty capacitors. You can examine the capacitors in your LCD TV or monitor and actually see if they are bad.
If they appear bulged on top, then they need to be replaced.
New capacitors will solve a host of problems in LCD monitors and TV's and will extend the life of your monitor or TV by several years.
Check the cables, connectors and connections.
If your TV, flatscreen, or monitor is more than 5 years old it is more like to have suffered a component failure.
Take it to a repair shop.
https://www.youtube.com/watch?v=TR2iWN6b-LY
LCD TV Repair No Power Power Supply Common Symptoms Solutions How to...

sounds like something is shorting and the safety on the psu is kicking in.is the backlight behind your screen flickering prior to it cutting out. if so sunds like a cft has gone faulty. can be fixed though

ur tv went off might be due to a power flucatuation
the component to switch the tv on is damaged so u hv to take it to a trusted technician or ur product care center.

i had this problem myself, press the power button and when it goes green press it again but hold it for 10 seconds, then it should work fine mine did good luck :)x

follow the steps below using your sky remote.

TV
RED + SELECT
TV
0117 (manufacturers code)

press power, if this turns tv off press SELECT to save. if not press TV then POWER again. when the remote turns your telly off remember to press your SELECT button to save it to your sky remote.

Enjoy

Cheers

Little Dish Fitter

hi right now samsung is the best tv maker out right these problem dont happen with samsung what would be good to do is call them and let them know your problem cause you have a year protection on it thats if it less than a year

Your pdp panel sounds faulty - Count the red flashes this is an error code.

You Have bad cap's on you power supply board causing the
5 volt line to go low. Call a service provider.