SOURCE: Zts has no Power when Blades Engaged
check the coils
I had the same problem 1 coil went out.
I replaced both to save time and money later
SOURCE: Knocking in mower deck or belt clutch when engaging blades, motor bogs / slows down
YOU MAY HAVE A BENT BLADE OR EXESSEIVE BUILD UP UNDER THE DECK
SOURCE: I NEED BELT DIAGRAM FOR MY HUSQVARNA RIDING MOWER
http://www.usa.husqvarna.com/home.aspx try this out for your answers, I hope this helps you. MERRY CHRISTMAS!
SOURCE: Blades will not engage on Husqvarna riding mower.
Could be a broken belt, loose belt (stretched) or something is under the mower deck jamming the blades. (stick for an example)
SOURCE: blades making a bad noise
Well I would say you have a bent blade, a blade has a loose connection to the bottom of the mandrel, or a mandrel bearing is going out. Visual inspection will reveal much, just look under the deck. A bad mandrel may appear to have "runout" when viewed from the top while spinning as contrasted with a good mandrel. Viewing the one in the center while deck is working is going to be a challenge. If you decide to replace a mandrel, do yourself a favor and take a picture of the deck belt before you take it off so you know how it goes back on.
246 views
Usually answered in minutes!
×