JVC TV-20F243 20 in. TV/VCR Combo Logo

Question about JVC TV-20F243 20 in. TV/VCR Combo

1 Answer

14" t.v. when i increase the Volume

I have a compact 14" t.v. when i increase the Volume Up the picture gets distortion (disturbing from sides) and start flickering, and when i lower the volume down the picture gets good as usuall. any solution?

Posted by Aharon Levi on

Ad

1 Answer

Anonymous

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 337 Answers

I believe you have a regulation problem ,when you increase the volume the audio output IC draws more current therefore the power supply has to keep up with the increase in current,the symptom might happen if you increase the brighness to the max as well,the voltage changes need to be monitored closely to diagnose what component is not doing the work.If you are familiar with tv service this is a problem that will give you a challenge but if you are not too familiar be safe and let someone else get the headache.Let us know how it goes or if you need more information.

Posted on Nov 07, 2006

  • Anonymous Nov 07, 2006

    Your rating response is also important.

×

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

I have a digital piano and the sound is distorted when play notes on the left hand (.i.e notes lower than the middle c)side of the keyboard note?

You might want to try this question in a different category...It was posted under GPS Devices....
Dec 30, 2014 • GPS
0helpful
4answers

Crazy (red) disturbances in image

I have a very similar problem. My HP-4272 is about 3.5 years old. Started off with the bottom half going black for a couple of seconds. Then the top would flicker. Now I get the following picture... Not sure if I need to replace boards (Y-buffer lower, upper, and/or Y Main Board)? or if something just needs to be "adjusted"...

cb96c75.jpg
0helpful
1answer

How do I change radio volume on the alarm?

This clock is supposed to have an automatically "increasing" volume feature (starts off low, gets louder over a minute or so).

If not sufficient, look on the top right side of the clock, there should be an up/down volume control. It is a black oval-shaped button with a picture of a sound speaker in the middle. Push it upward to increase volume and downward to decrease volume. Unfortunately, you have to have a flashlight or light on to see it because none of the controls are illuminated.
0helpful
1answer

I have a CS361 plantronics wireless headset and I get alot of echoing when I get calls in and out, and when I call my coworker

Reduce speaking volume by changing the speaking volume
major adjust switch setting. See page 15 in the User's Guide (link below).
• Point microphone towards your chin.
• Listening volume too high on phone. If your phone has a handset
volume control, lower this until the distortion disappears.
• If the distortion is still present, lower the listening volume adjust
button on the headset. If the distortion persists, select another
listening volume major adjust switch setting. See page 14 in User's Guide.
• Base is too close to computer or phone. See page 9 in User's Guide for
proper positioning.

For further help, this is the link for the Plantronics Wireless Headset User's Guide.

Good luck from Headsets Direct!
0helpful
1answer

Volume too loud when page is used

T7316 speaker keeps cutting out. changed phone out. same problem
1helpful
1answer

Insignia NS-A2111

Cant help with diagrams but have you tried "freeze". Its a spray that cools components to see if they are breaking down thermally which does sound a little like it could be possibly. The cold component then rights itself when sprayed for a little while till it get warms again.

Best of luck
0helpful
1answer

Picture often flickers and image distorts every few minutes

The trouble is most likely in the Video processor. If the trouble looks like its tearing the video only from side to side it may be the line doubler circuit. Some of these boards are no longer available but a good TV tech may be able to componnent level repair it for you.
0helpful
1answer

My Hitachi 65SWX20B Model, made in 02, just developed Picture disturbance

Can you post a picture of the set. This might be a convergence problem. seeing the set will confirm this.

Thank you,
shuttle83
0helpful
1answer

Playback is slightly distorted picture flickers

get a video head cleaner and clean it...ur head is just a little dirty
Not finding what you are looking for?

115 views

Ask a Question

Usually answered in minutes!

Top JVC Televison & Video Experts

The Knight
The Knight

Level 3 Expert

76835 Answers

Ekse

Level 3 Expert

13435 Answers

 Grubhead
Grubhead

Level 3 Expert

5720 Answers

Are you a JVC Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...