Question about Hotpoint WMA76 Front Load Washer

2 Answers

Faulty door which keeps beeping

Washing machine stopped half way through a wash saying door not shut. so now the washing machine keeps beeping saying door not shut. But the door is shut. it will not do anything but beep.......... please can somebody help.

Posted by MICHELLE GREEN on

  • Anonymous Mar 16, 2014

    My whirlpool affinity washing machine keeps beeping and has dr on the display but the door is closed!!

  • Anonymous Mar 18, 2014

    Washing machine door locks when it is switched on but does not do anything

×

Ad

2 Answers

Anonymous

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I had a similar problem which was resolved by replacing the door interlock switch (cost about £10.00).

To get to it you need to disconnect the mains then remove the top lid. You can then see it by looking down the inside to the right. Remove the 2 screws inside the door opening and you can then lift it out after disconnecting the wiring plug.

Replacement is the reverse of the above, a 5 minute job.

Posted on Dec 29, 2007

Ad

Dov Dror

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points
    All-Star:

    An expert that got 10 achievements.
    MVP:

    An expert that got 5 achievements.
    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 641 Answers

The door could be closed physically but the not electricity because a defective lid switch that should be replaced. Good luck!

Posted on Aug 24, 2007

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hotpoint wma48 shuts down anywhere during cycle
which suggests possible the faulty door lock has been fitted with another faulty door lock. this has happened to me on two or three occasions in different situations.

May 23, 2016 | Hotpoint Washing Machines

1 Answer

Whirlpool deluxe WFW9150ww01
Replace the analog level pressure switch, it sounds like it is bad, and the machine's overflow switch is the only thing stopping the fill from flooding your house... Whirlpool Washing Machine Pressure Switch WPW10239066

Jun 04, 2013 | Washing Machines

1 Answer

Simpson encore 605 fault code are as follows during wash process stop suddenly, strat to beep and all lights are gone except the Maxi light . It flashs while beeps
Hi, my Simpson encore 605 wash machine wash on the half way keeps beeping, and the maxi is keep flashing. What kind problem it is?
Cheers!

Feb 12, 2012 | Washing Machines

1 Answer

Washing machine keeps beeping then all lights and screen start flashing.
i would guess that you have a faulty main board, the quickest and surest way to determine the problem and that is to replace it with a second hand board out of an known old machine which has faulty seals.

Dec 11, 2011 | Fisher and Paykel Washing Machines

1 Answer

I have a LG Fully Automatic Washing Machine - WF960R. It's been working fine untill now. An error code 'dE' keeps flashing after the water filled up and the wash load started. Troubleshoot...
Replace door/lid lock.

Aug 24, 2017 | LG Washing Machines

1 Answer

I have an electrolux EWX14440W Washing machine,
could be your door interlock is faulty

Mar 01, 2010 | Washing Machines

1 Answer

Zanussi ZWF1430W washing machine beeping.
you must replace the door switch

Jan 29, 2009 | Zanussi ZWF1430W Front Load Washer

1 Answer

My washing machine wont work properly!!!!!
may i suggest that you check that the filter is not blocked, i had a very similar problem to this except my machine stopped washing and started making a beeping noise.hope this helps

Aug 03, 2008 | Washing Machines

2 Answers

Washing machine - door problem
it sounds like door mechanisim has fallen off.remove the top of washer/dryer and look down the front to where the door catch shuts and see if there is anything attached to it.if not your have to reconnect it.Let me know and ill give ya more details

Sep 03, 2007 | Hotpoint Ultima WD72 Front Load...

2 Answers

Washing machine door sensor
I must differ with you. This machine does have a computer control card located within the timer base assy. Thee 5 beeps are a response from the computer that informs of a faulty signal between the computer and the door sensor

Nov 09, 2006 | Roper RAS8445KQ Top Load Washer

Not finding what you are looking for?

View Most Popular

WMA76 Front Load Washer

  • Washing Machines

Related Question

Hotpoint wma48 shuts down anywhere during cycle

  • Hotpoint Washing Machines

Open Questions:

0 Answers

pcb wiring diagram the pcb panel at the top right corner behind the front panel on the main machice

Jun 03, 2014 | Hotpoint WMA76 Front Load Washer

0 Answers

How do I change brushes on hotpoint WMA76S

Apr 30, 2014 | Hotpoint WMA76 Front Load Washer

0 Answers

Door won't shut properly

Jan 23, 2014 | Hotpoint WMA76 Front Load Washer

0 Answers

clothes wet

Dec 10, 2013 | Hotpoint WMA76 Front Load Washer

Related Topics

Hotpoint WMA76 Front Load Washer Logo

544 people viewed this question

Ask a Question

Usually answered in minutes!

Popular Questions

Hotpoint Ultima WF860 Front...

Hotpoint Aquarius WD640 Front...

Hotpoint Aquarius WD63 Front...

Hotpoint Aquarius WMA42 Front...

Hotpoint Aquarius WD63 Front...

Top Hotpoint Washing Machines Experts

Richard C Cohen
Richard C Cohen

Level 2 Expert

171 Answers

gbob59

Level 3 Expert

3063 Answers

Cindy Wells

Level 3 Expert

6238 Answers

Are you a Hotpoint Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...