My Onkyo TX-SR601 display lights no longer work. The unit works fine other than that. Any suggestions?
Hi ripper
The unit has a built in display dimmer, with a button to control the level of brightness from the display both on the remote, and the front panel.Try this
regards
Graeme
"Not available in Zone 2 mode" Setting not allowed because the Zone 2 mode is turned on.
"Zone 2 is not On" Will not work because the Zone 2 has not been turned on.
TURN ZONE 2 ON.
Register and download the manual for free at retrevo.com
http://www.retrevo.com/support/Onkyo-TX-SR601-Receivers-manual/id/365ag212/t/2/
Page 55 shows the prerequisite settings for using the surround back terminals for Zone 2.
Page 60 describes USING Zone 2 and points out that only analog sources can be used with Zone 2. Are you trying to use digital sources? Read the notes regarding REC OUT.
784 views
Usually answered in minutes!
My Onkyo TX-sr601 unit works fine but no display. I have removed the front cover and the board, and see that the display section of the glass has a silver black spot, indicating possible short on one spot. I beleive that it is simple to replace the whole board since the display is most likely, not sold separately. Can I buy this board without going through red tape and all those you shouldn't do this and that.... I have made curcuit boards for all other electronic devices and would attempt to fix this display, but would like to buy the part. Can you help?
My TX-SR601 works fine, but the display lights no longer work. Any suggestions on how to fix this? Is it worth it?
×