Procan vcr will not unlock, please help

Usually a full erase and firmware restore is needed to recover from that situation. The exact process depends on your model of tablet. The attached video shows it for a typical Procan tablet.

This process will erase all of the data on the tablet. Hopefully you have a backup.

You can contact PROCAN directly to see if the remote is still available: http://oncorpus.com/
Or check this sites:
http://www.everytvremote.com/remote-control/rca/244876.aspx $29

Hello, the process to do this is fairly simple. Just follow the step provided from the link below, and you will be good to go!!!!!

http://www.dishnetwork.com/SupportSection/power-scan-instructions


Becki Barned
DISH Network Customer Service

I read the user's manual again. I misunderstood and held both on/off button and vcr1 button at the same time. I should only have been holding one of the buttons for ten seconds or untill the vcr responded=-=-=-=-=-DUH !

with your remote just hold on the power button! and you will get a cheery hello!!

This should help you

Proscan 19LA25Q 19" LCD HDTV at Crutchfield.com Proscan 19LA25Q 19' LCD HDTV: Detailed Info, Features and Specs, and Photos. ... Instruction Manual; Product Registration Card; Limited Warranty Card ...
www.crutchfield.com/ISEO-rgbtcspd/App/Product/Item/Main.aspx?i=68319LA25Q - 46k

I just had the same problem and found a solution on the internet that worked. Hopefully you still have the VCR's remote control. Press and hold either the on/off, VCR1 or VCR2 button on the remote. I pressed the VCR1 button and held it for about 5-7 seconds. It released the lock and worked fine afterwards. The lock is some kind of childlock devise.

you must have the vcr on child lock.should be somewhere on your remote to switch off or go through menu

Sounds like it's wired up wrong...try this:
take cable line to VCR in, VCR out to cable/receiver box(if you have one) then box to TV...it sounds like the vcr is getting the channels from the box and not the vcr...you will need to have the vcr scan the channels (round in the settings menu) You will also be able to watch and record 2 different things.

My Proscan PSVR74 turns on, says "Hello" and immediately goes to Stop and turns itself off. Is there any hope for this machine?

Joe