Question about Humminbird Boating
All the functions are working including the demo but there is no transducer? Why would this be, I have checked the plugs are in the correct possitions and connected. Could it be possible the transducer units are damaged from wrong polarity or do they only get the power from the unit itself. If connected the wrong way the unit does not switch on.
Posted by Anonymous on
SOURCE: mice ate transducer wire
cut the wire and re connect with crimp connectors and then seal withe heat shring tubing and a heat gun (put the tubing in first) or you could solder the ends together and heat shrink tubing over the individual wires. So long as you have a good water tight connection ther should be no adverse affects to your equipment.
Posted on Sep 19, 2008
Batteries could be too low, or unit could think batteries are too low because it is not set up for your battery configuration. (voltage, amperage, deep cycle, wet, gel, agm etc.)
I am not sure how you set up that model but the manual should explain it. If you don't have one you can get it online from xantrex.
Posted on Jan 08, 2009
Had the same issue with another brand. Turned out the transducer cable was picking up noise from other cables (power, trolling mtr. etc). Try moving the transducer cable away from any other cables. I put the cable in a 1/4 " plastic housing up to the point where it was above deck and it stopped all the strange stuff. Not sure about the temp issue??
Posted on Jul 21, 2009
Tips for a great answer:
Sep 03, 2018 | Humminbird Boating
Sep 18, 2017 | Humminbird Boating
May 10, 2015 | Humminbird 525 Fishfinder
Oct 05, 2014 | Humminbird Boating
May 29, 2013 | Humminbird 1198C SI Side Imaging High...
Aug 29, 2011 | Boating
Feb 12, 2011 | Sport & Outdoor - Others
Jan 12, 2011 | Humminbird XNT Transducers XNT 9 20 T ...
Dec 27, 2010 | Sport & Outdoor - Others
62 people viewed this question
Usually answered in minutes!