Need A New Wiring Harness

Here's a wiring guide for the fuel pump on a 2000 Cadillac Deville: 1. Remove the fuel tank and access the fuel pump module. 2. Disconnect the electrical connector from the top of the fuel pump module. 3. Locate the wiring harness that runs from the fuel pump module to the car's electrical system. 4. Cut the wires on the old fuel pump module connector, leaving enough wire to splice the new connector onto. 5. Connect the black wire from the new fuel pump module connector to the black wire in the car's wiring harness. 6. Connect the purple wire from the new fuel pump module connector to the purple wire in the car's wiring harness. 7. Connect the gray wire from the new fuel pump module connector to the gray wire in the car's wiring harness. 8. Connect the black/white wire from the new fuel pump module connector to the black/white wire in the car's wiring harness. 9. Connect the new fuel pump module electrical connector to the car's wiring harness connector. 10. Reinstall the fuel tank. Note that it is important to follow the wiring guide carefully to ensure proper installation and avoid damaging the fuel pump or electrical system. If you are unsure about any step of the process, it is recommended to seek assistance from a professional mechanic or refer to the vehicle's service manual.

I assume you are referring to the Mass Air Flow (MAF) sensor in a 2007 Chevrolet Avalanche.
The MAF sensor has a wiring harness connector that connects to the sensor. If you need to replace the MAF sensor or the wiring harness, it is important to ensure that you connect the wires correctly to avoid any damage to the sensor or your vehicle's electrical system.
Here are the steps to replace the MAF sensor or wiring harness in a 2007 Chevrolet Avalanche:

1. Locate the MAF sensor on your vehicle. It is typically located in the air intake system between the air filter and the throttle body.
2. Disconnect the wiring harness connector from the MAF sensor by pushing down on the release tab and pulling the connector away from the sensor.
3. If you are replacing the wiring harness, connect the new wiring harness to the MAF sensor by aligning the pins and pushing the connector into place until it clicks.
4. If you are replacing the MAF sensor, connect the wiring harness to the new MAF sensor by aligning the pins and pushing the connector into place until it clicks.
5. Ensure that the wiring harness is securely connected to the MAF sensor.
6. Start the vehicle and check for any warning lights on the dashboard.

Note: The specific wiring colors for the MAF sensor on a 2007 Chevrolet Avalanche may vary depending on the engine size and other factors. If you're unsure about the wiring, it's always a good idea to consult a mechanic or refer to the vehicle's repair manual.

I need the manual of panasonic car color tv tuner model TBM850425

You don't need a wiring harness for the radio unless you lost the one that came in the box with the radio.

You can find a wiring harness for your car here.
Fit My Car
That will list all the things that are compatible with your car, including aftermarket wiring harness to connect a stereo.

http://www.uneeksupply.com/servlet/the-732/Dual-Wire-Harness-XDVD8180/Detail

make sure all grounds are connected. usually it is something easy or stupid.it should work.an obd-II scan may help pinpoint the problem.

Try this link Mr. fchlein.


Nate P.

Here is the link for your owners manual: http://legacyproducts.tdk.com/support/pdfs/5900UserManualEN.pdf

call 1800-634-8606
Part # 134140-21000700

YOU CAN ORDER IT FROM PACPARTS.COM OR ANDREWSELECTRONICS.COM