How to reset my washing machine blomberg

Try disconnecting the mains power to reset the Control Board.

Hi,

please check the troubleshooting section of your manual for any procedure related to the flashing-start sign. If this is not the in the manual, then you might need to schedule servicing/repair on the machine from the manufacturer by calling 1(800) 459-9848. Thank you.

This machine is by far the worst I have encountered for finding parts. I just went through 18 pages and there was nothing that looked like a control panel. Most sites has a Parts Schematic by the area of the machine the parts are in.

https://www.google.com/search?q=blomberg+washer+wm87120+nbl00+control+board

Manual

https://www.manualslib.com/manual/622179/Blomberg-Wm-87120-Nbl00.html?page=19#manual

..

There are two locks on them.

Child Lock, C-On, and C-OFF.
and
Door Lock due to water level.

The latter one should unlock a few minutes after the wash ends. If it doesn't, you need a service call. Cutting the power should reset it.

https://www.google.com/search?q=Blomberg+washer+door+lock+symbol

..

Try the motor brushes

It's the latch on the door try clean the switch it's not making contact

Door latching or lock error
·Door not detected closed
·Check door is closed
·Check door catch and latch
·Check door lock wiring
Check door lock

Bad door switch or bad water senser.
On older models it's usually the transmission
coupler.

We found a way to reset the computer and solved the problem.
1. Press and hold pause turn off machine and turn back on holding pause all the while.
2. This should reset the computer. All lights will light up on LCD display.
3. Release pause button. Turn off machine, turn back on and begin a new wash cycle.
woo hoo!

I have Blomberg WM87120 NBL00 Product code 717518110 and had flashing Lock in display. Bought and installed new lock and no change. Display still flashing lock. Used following procedure and every is working now.
Press pause button and hold down while turning off machine.Continue to hold pause button and turn power back on. If numbers come up on display make note of them for future reference. Release pause button and all lights on display will light up. Turn power off again and then turn back on. If machine was in a cycle it should end it and then return to normal operation. .Dont know if new lock made a difference. Try the reset procedure first.