Code how to break code on phase liear uv8

Hola Hope this might help a little. You may have to read. Sorry, I can\'t post too many pics or video, but this link should help I hope. The link provides details and goes over the wiring. If not, google it or check on YouTube.
Instruction Manual - Page 1
http://www.helpowl.com/q/Jensen/UV8/Technical-Support/phase-linear-uv8-schematic/9778

You can let your kidwatch DVD but not while your driving unless the screen is out of the view of the driver

I had the same problem and I was able to fix it myself. call me and I can help you over the phone 951-334-2297 ask for George.

CALL 919 562 5445

It sounds like you have a factory amp in the vehicle. Check behind the radio to see if you have the blue wire from the deck hooked up to anything. You probably do. So take the blue with white stripe wire coming from the deck and hook that up instead of the solid blue wire.

you may check the power plug

for the uv8 to bypass the parking brake to watch dvds you have to take the pink wire and put one end to one of the screws on a two screw toggle switch connect the other end of the pink wire to the other screw and connect that to the black ground wire

Hi,

There are two ways of bypassing the brake sensor in a Phase Linear UV8:
1. ground the pink wire using a toggle switch;
2. Use the unit's built-in bypass software.
a. Select "Tuner" mode (AM/FM);
b. Press the "Setup" button;
c. With the use of the remote, press 5, 4, 3, 2, 1, and then press and hold 0 for a couple of seconds or until the menu changes. d. d. Display should show hidden menu. Among the options would be to turn ON the "Brake override";
e. Press th "X" on the bottom leftmost corner.

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards.

Thank you for using FIXYA.

that model has a adaptor that comes with and you plug that j-link to it i have one.

I have same problem with same uv8 but i use remote to activate am/fm then hit setup on rem.enter 543210 and a new menu came up. ( listening for the beep after each 3 is pressed ) select the hammer in upper left hand corner of screen, select brake bypass to on, then hot the X near bottom os screen. this works for me it should work for you.