Cit200 how to raise the volume of the linksys cit200 hand set

Hi ,nobody know any solution for this
DRIVER for MAC OS (Lion) I need to install my CIT200 on a Macboook pro

All Linksys drivers are Windows based. No drivers for the MAC for the CIT200

Check out:
http://drivers.softpedia.com/get/Other-DRIVERS-TOOLS/Others/Linksys-CIT200-Driver-370.shtml

You need to download and install vista driver version 3.8.2 from the Linksys support site.

This may help .. Open Control Panel and open the Sounds and Audio Devices item. If you have separate Voice and Audio tabs showing, set the Voice for the CIT200 and Audio to your Sound Card. I'm viewing this in win XP. Vista probably differs somewhat.
Hope that helps out some.

~Myrddin
.end.trans.

If you're running XP, go to the control panel, open the Sounds and Audio Devices item. Check for a Voice tab there and adjust the devices to your cit200. Hopefully that'll get you talking correctly.

~Myrddin
.end.trans.

You need to download setup wizard for vista.

Click the link and look for CIT200

http://www.linksys.com/servlet/Satellite?c=L_CASupport_C1&childpagename=US%2FLayout&cid=1175230420666&packedargs=site%3DUS&pagename=Linksys%2FCommon%2FVisitorWrapper&lid=2066646109B01

The problem has been solved .. . thank you . The hand set had in fact been somehow un registered from the 'Sender ' . I looked up how to register the hand set ( no way would I have thought of holding down the page button on sender for a few seconds , actually until it starts to flash and then you have (via the menu ) to get the hand set into register mode ( you will need your PIN no. if you changed it from factory default ! If you haven't changed it then factory default is ' 0000' ) . . . punch that in to the hand set and then bingo , they are in touch again . . . .

It took HOURS to get it right . . . I tried removing CIT200 and Skype and then reload into computer . . . and I'm not sure now if I have the upgrade or not of CIT200 . . . this morning had the on going problem of phone saying ' unavailable ' and the only way out of this is to reboot my computer . . . that mostly works ! Apart from these BIG niggles the system is clear and good when all configured . . . NOT found the answer to the Niggles yet ! . . . . . ( Why no hard copy of the user manual . . . ridiculous!)

riknvic ..

All Linksys drivers are Windows based. No drivers for the MAC for the CIT200

When the CIT200 is installed and active, it is your default speaker. You have to disable the CIT200 to hear sound from your speaker again. THAT IS A DEVICE LIMITATION.