How channel 6.1

315Mhz remote relay switch kits - 2 channels - Seeed Studio

www.seeedstudio.com/.../315Mhz-remote-relay-switch-kits-2-channels-p...

This remote switch allows you to remotely control any 12 Volt DC device. ... to supply 3-5VDC to the "+12V" pin,(Caution: the 12v is an error silk screen on PCB, ... Is there a wiring diagram to show how you connect the sender to the GPIO pins?

Amazon.com: 1 Channel Wireless Controller (On/Off) 12V ...

www.amazon.com > ... > Lighting Accessories

Amazon.com, Inc.I wired this remote relay to a fuse block below the motorhome frame. ... Here's a (very) short video showing how the remote control works. I love it! It's very easy to ...

12v wireless 315 MHz remote control relay board 6-channel ...

? 4:36
https://www.youtube.com/watch?v=JBzL0MIno2w
Feb 2, 2013 - Uploaded by Julian Ilett
12v wireless 315 MHz remote control relay board 6-channel ... The relay board takes 12 volts in and there ...

Universal remotes have have very few options, just basics such as volume, channel, mute, power. Sleep timer will not be there. for that you need to get the original remote.

The fault is with TV. Not with remote control. The TVs memory IC need replacement.

Register and download the manual for free at retrevo.com

http://www.retrevo.com/support/Panasonic-SC-HT07-Home-Theater-Systems-manual/id/354dj098/t/2/

Plug a device that actually has a 6 channel analog output into the DVD/DVD 6Ch inputs. Configure THAT device to put out 6-channel analog.Select ANALOG 6CH on the remote (page 16).

Hello! If your tv just won't cycle to the correct channel you can change the setting if its tv1 you need a channel scan if it's tv2 try these steps:
http://www.dishnetwork.com/SupportSection/video

Daniel Busa
DISH Network Customer Service

Try website like Remotes.com to buy an original remote.Than try remote input button like 1,2,3 should be in one of it inputs .This is a digital tv,will not work on channels.

You would need the user manual and the specific remote code for your TV to get this work properly. Just send the model numbers of TV and remote to http://manualfox.com/remote.htm and they will come back with a solution.

Press tv on the Sky remote

press and hold select and red until the led blinks twice
type in 0 0 6 0
press the power button, if the tv turns off then the press select and the remote should work all the tv functions.

If the tv does not turn off then press tv then the power button and keep doing this until the tv turns off, once it turns off press select and it should work.

If you have any problems let me know

Dazz

1.) Press the TiVo button on the remote (at the top)

2.) Scroll down to "Messages & Settings" and press 'Select' on remote

3.) Scroll down to "Settings" and press 'Select'

4.) Scroll down to "Channels" and press 'Select'

5.) Press 'Select' on "Channel List"

6.) Pressing the "ENTER" button on remote will let you change Channel Line-Up

If you take a working remote, point it at the TV and hit "3", then "ENTER", does the set go to channel 3?