Usercontrol automatically displayed when bootup

Did you check the adjustment setting on the brightness and contrast?
These two setting can be moved and stop the CRT from displaying,
Please move these two setting to MAX and see is there any image on the display.

connect another cable as follows
1-red
2-green
3-blue
4-gnd
5-gnd
6-red gnd
7-green gnd
8-blue gnd
9-+5v from display card
10-stand by
11-synchronus ground
12-sda
13-hsync
14-vsync
15-scl
the numbers of pin are given
under pin

try to check all components (smps section )

HI all,

The problem im facing is, im using a Samsung samtrong 56V monitor, there is horizontal line appearing in the both ends of the monitor screen which gives a mirroring effect. ( for ex: if ya move the cursor on that it will show multiples of cursors displayed in that line only.)

Please suggest me a method to solve this issue. are there any patch avail for this if so please send a link to download.

thanks a lot

OSD = On Screen Display. Once loaded it is normal for the OSD to stay on your screen untill it times out or you Exit it.

Please change the switch pannel  and check 

samtron 56v monitor wosulation problem how can i sovle this problem

its seems you have a cold solder.

change the eprom (A41dDC) after connect pc then switch on monitor
[email protected]

change the 5v regulator 7805 which is the supply for microprocesor