There r two small plastick stick which is attached with the printer front cover.just open this cover and inspect it 1. one plastic cover which is stated left side of your printer. it hit the power switch conector.after hitting it the printer motion start.
2.the second stick attach right side middle of the printer cover.it hit the black scanner sensor.after hitting it the scanner became on.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
check all the catridge installed ok after finding the gatridge ok if the problem not solved , then uninstall the printer driver and restart after restarting the machine then again reinstall the printer driver properly
I have a z600 that i use. If not used for about a month the ink does clog the print nozzles and eventually ink cartridge does dry out. To avoid this even if i dont have to print anything I run a diagnostics test that prints out a nozzle aligment test every two weeks.The great thing about this is that it uses very little ink.You can find this test in your software that was provided by Lexmark. This will keep your nozzles cleaned and you will notice this helps extend the life of your cartridge.
Any chance you can post a scan of one of the faulty pages ? This will make it easier to assess the fault.
Print off about 10 pages of a page that is affected by the lines. Look at each page and see if you can detect a recurring pattern over any of the pages.
If there is a pattern, chances are it is probably the PCU that is marked.
Without actually seeing a print sample or the machine, my bet would be on the black print cartridge. Even though it reads a an acceptable level of toner, the cartridge itself sounds like it has developed a proble.
1. It's the most obvious
2. It't the cheapest place to start. If it does not correct the problem, you can still use it later.
3. It's the problem in about 80% of these types of cases.
4. I know it should be fine, but if things didn't go wrong, I wouldn't have a job!
Let me know. If not we'll investigate further.