How to clear red like wrench in toshiba e-studio120 copier

Maintenance count reminder to perform routine maintenance by technician ..

Hi:

L-1 means that the scanner assy is not moving correctly. There is a scanner lock in the cavity where your copies come out. Just bend over and look up in the cavity and you should see a round knob. It has a lock and unlock icon. Make sure that is completely unlocked. If it is partially locked then this will keep the scanner from moving and cause the L-1 error.

Andrew

Did you pull the plastic tape off of the toner cart?

The H4 error is related to the Fuser Unit not reaching the correct operating temperature in the correct time. You can try clearing this error with the following:

Make sure that the machine is switched on and the error is displayed. Enter the Service Mode by pressing the following keys # * Clr *

Enter 14 and press Start. Then power off the machine, wait 30 seconds and then power back on. The error should have cleared. If not then you will need to call in a service engineer.

Press : CLEAR key - INTERRUPT key - O - INTERRUPT key.
The copy quantity display goes off and the machine is ready to receive input of test command number.Enter the two digit number to select the test commands.The test command number entered will be displayed in the copy quantity display.Press the PRINT switch.The operation corresponding to the entered test command number will be performed.For the test command 13 and 14 since test commands 13,14 are used to clear the contents of the diagnostic status (U1,H3,H4)stored in the LSI,the diagnostic mode will be automatically canceled after completion of the test commands.

seems like heat roller problem.
enter code C, exposer light buttom, C and exposer light buttom , then all the indicator in the machine goes off. then enter 14 and press print buttom. Now your machine must work. If not Pls refer to technician.

wrench means service problem. "snowflake" I assume you mean the developer symbol. Machien on - depres the clear key then the expose key then the clear key again then the expose key you are now in simualtion mode. depress 20 print 01 print this will turn of the maintenance or wrench code. Depress 24 print 06 print will clear the developer. turn on and off

press the clear/stop and 8 key, and get the code

Performing a Fault Reset 14 will reset your WorkCentre and will help to clear error codes.

1. Find the pink Clear button on the Control Panel of the WorkCentre.
2. Find the button below the word Auto.
3. Press these buttons in the following sequence: [Clear], [Auto], [Clear], [Auto] NOTE: All of the lights on the Control Panel should go out and the LED Display should go blank. If the lights do not go out, then repeat step 3 until they do. It may be necessary to increase or decrease the pace of the [Clear], [Auto], [Clear], [Auto] sequence.
   
4. Press the [10's] key one time and the [1's] key four times to enter '14' in the LED Display, as if you were to make 14 copies.
5. Press the green [Start] button.
6. Press the pink [Clear] button two times.
7. The WorkCentre should now warm up and come to ready.
8. If the above steps do not clear the error code, repeat steps 3 to 6 a second time.

Press the clear and the 8 button at the same time . This will give you a error code. I will guess that you have a "C7". If you still want to fix let me know error code.