How to remove agitator from ge washing machine model whdsr316g

Might be a blown line fuse located in the red and white wire in the harness, you will know it if the green idiot light on the motor ain't a blinkin.

Got questions? I will be here all week.
Rate the answer and thanks fer using Fixya!





If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

how to remove agitator from GE hydrowave washer machine?

most likley the motor has startd to burn out or the brushes are warn out it could also be sezied up on you,, the agitator bearings may be sezied up

Sounds like the nut that holds the agitator on to the shaft is not tightend down or the agitator is not fully "locked" into place on the shaft.

Mine is 1 1/2 years old and this worked for me

unplug from power for at least 30 seconds

turn the dial to spin but don't pull out

plug back in to power and open and shut completely so switch is engaged solidly 11 times in 15 seconds.

pull out knob to turn on

This should clear a error code.

hope it helps!

hi, reset the printer.
open th right door,without paper then close the door
it work
thank you

Check the lid switch first.

Unplug machine. Change load type to medium. Clean door sensor. Set knob to drain and spin. Plug machine back in to powr. Open and close door 10 times in 15 seconds. Pull knob to activate drain and spin.

If you remove the top cover to the agitator, inside you will see a I believe 9/16" nut.  Remove this to take the agitator off the shaft.

Pull up sharply on the agitator to remove it from the shaft. Check the agitator mounting cup underneath it is probably stripped out. It is a replaceable part.
If the agitator is difficult to pull up,use a old strong leather belt under the agitator and pull it off using the belt.