Binatone vantage handset says range out - Lands Phones

Hi, Am Levy And here to show where you can find the user manual for binatone idect vantage, I will give the link to where you download or use it online either is your choice. https://www.manualslib.com/manual/537701/Binatone-Idect-Freedom-Twin.html

From Manual:
To check whether a handset is registered, make sure mains power to the
base unit is switched on and the handset is within range. The handset's
display should show its number and the <Antenna icon> should be steadily
on. If the display shows
again using the following process:
1. On the base station, press <MENU/OK> and <UP/DOWN> to show
REGISTRATION, and then press <MENU/OK> to put the base station into
registration mode. The base display will show "PLEASE WAIT" and the
base will stay in registration mode for about 2 minute, so the following
handset sequence must be completed within this time.
2. Press <MENU/OK> and <UP/DOWN> to select REGISTRATION.
3. Press <MENU/OK> to display PIN?----.
4. Enter the 4-digit system PIN (default is 0000).
5. Press <MENU/OK> to confirm, and the display will show
PLEASE WAIT flashing.
If the handset registration is successful, the display will change to standby
mode with the new handset number and the <antenna icon> will stop flashing.
The handset will automatically be allocated the next available handset
number. If the handset registration is unsuccessful, the <antenna icon> will
still flash

with cordless phones the problem is that the hand sets have to be recognized by the base station ( paired) and unless you have the exact hand piece make and model this pairing and recognition will not happen
if you can get 2nd hand units for the 3325 base then the base will accept them ( any number of additions ) but if the hand piece is different it will not work
you you need extra hand pieces then it may be best to consider a new system where you can buy extra phones and chargers

If the display says out of range, it means it can't connect to the base station. Could be because it is to far away, or it is switched of, disconnected from the mains or just defect.

I would try changing the batteries, they don't last forever and are usually the problem

To unlock handset for Binatone mobile handset 3410 you hold down the star key (*)

take the batteries out of hand set and put them back in within seconds. That should do the trick.

Follow the below links for your manual
http://www.binatone.com.au/pdf/e920_single.pdf if you have a single handset

http://www.binatone.com.au/pdf/e920_twin.pdf if you have two handsets

http://www.binatone.com.au/pdf/e920_quad.pdf if you have four handsets

Hope this helps
http://pchelpforanyone.blogspot.com