Question about LG Flatron F700P 17" CRT Monitor

2 Answers

Screen goes black

I have a flatron L1751S and every few minutes the screen goes dim and I have to restart the monitor just to see things again. Is there anyw aay to fix this? what is a lamp controler?

Posted by tritz ktsesdf on

Ad

2 Answers

Anonymous

I have a Gateway FPD1975W. I tried turning the brightness down but it kept blacking out. The lower I got the more it did it. I turned the brightness up and it stopped. At least you got me looking in the right area. Thanks. RICK

Posted on Feb 25, 2008

Ad

Anonymous

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 3 Answers

I recently had a similar problem with a MAG LCD monitor. Try the following to see if this resolves your problem: - set brightness to a lower level. On LCD monitors you can go as low as 0 and still see the screen. With my problem when I set the brightness below 70% the problem went away. A few days later I turned it all the way up to 100% and the problem did not return. However I did not continue to keep it at that level. I found no need for it and find 50% to be exceptable for my needs. I would say yes it does have something to do with the lamp controler which controls the lamp brightness. I do not know all the technical reasons why a controler starts to have this sort of problem. If your monitor is still under warranty I would take advantage of the free repair otherwise keep the brightness below the level that causes the problem; for me that was under 70 percent. I hope this solution works for you. Perhaps there are others that can give you all the technical reasons why a controler starts to exhibit this behavior. Sincerely, Dean Kenneth Robinson

Posted on Aug 16, 2006

Ad

3 Related Answers

Anonymous

  • 16 Answers

SOURCE: 17"LCD Monitor

This problem is showing when the main PCB of the monitor failed. Contact the LG service provider in your area.Check this link to get the service center info
http://www.lgservice.com/

Posted on Feb 09, 2008

Anonymous

  • 1 Answer

SOURCE: LG L1751S Flatron Screen

My sister's monitor wont turn on at all. She was shutting her system down due to a storm rolling in, and it said windows shutting down installing updates, while she is shutting it down. She turned it on today and the little light came on then it went off and hasn't been on since then. The Tower works fine but the monitor isnt turning on at all. What should she do? She has had the monitor at least 2 years no more then 2 1/2 years! And it is a LG Flatron 20". HELP

Posted on Aug 25, 2008

Mark Gough

  • 415 Answers

SOURCE: screen dead

since it's only 3weeks old as long as you have the receipt take it back .
Mark

Posted on Apr 18, 2009

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Why does screen go black after a few seconds

Hope this helps.... Your monitor has an inverter issue. You know it's an inverter problem when:
1. Your monitor starts normally and displays the startup/desktop screen for a while.
2. Then it suddenly goes off, leaving a blank (black) screen or a very dim display.

To fix this black screen problem, change the inverter board (based on your monitor brand).
Source(s): http://lcdmonitorrepair.annics.com
1helpful
1answer

Screen doesn't want to come on, then goes dim

The problem is caused by one of the inverter transformers, or one of the backlights behind the LCD screen is going.
3helpful
1answer

Asus Monitor boes blank and comes back after power recycle

1. You can see images on the screen for a few minutes. That means there is nothing wrong with your computer.

2. When your screen goes blank, if you disconnect and then reconnect the monitor, it shows fine again for a few minutes before going blank (or dim) again. That means the problem is not with you video card.

3. It always shows the image after reconnection for exactly a few minutes before going blank again. yes? this means that there is nothing wrong with your cable.

Conclusion: Sorry, but you do not have many options. I bleieve that the problem is with your monitor that's going bad. Its far cheaper to get it replaced than to repair it.
0helpful
1answer

Screen problem monitor

Check the flex cable, it might be loose. Disconnect the monitor cable from the computer, if the issue still occurs, points of failure as follows: ac power cable faulty monitor
0helpful
1answer

LG Flatron l1751S monitor

These are the possible reasons.
  1. your video card doesnt't support the resoltion you selected.
  2. you don't have the appropriate driver for your video card.
  3. or check your video cable
Solution:
  1. Try rebooting your PC.
  2. Reinstall or update video card driver. Know the brand and model of your video card then surf the net for drivers on their website.
  3. Try to lower your desktop video resolution. (1280 x 1024 Maximum Resolution)
If this things help you solve your problem, please rate me.

Thank you

regards,
-engrkoiled-
0helpful
1answer

Monitor Turns Black

Try reseating the Graphics card first..It may be loose. Or try it in a different slot.
1helpful
2answers

LG L1751S Flatron Screen

My sister's monitor wont turn on at all. She was shutting her system down due to a storm rolling in, and it said windows shutting down installing updates, while she is shutting it down. She turned it on today and the little light came on then it went off and hasn't been on since then. The Tower works fine but the monitor isnt turning on at all. What should she do? She has had the monitor at least 2 years no more then 2 1/2 years! And it is a LG Flatron 20". HELP
0helpful
1answer

Screen goes black and power light goes out after a few minutes

it would seem that one of the internal components has failed / overheated Dont open the rear of the monitor !

if pos drop it into your nearest pc repair shop and have is serviced it may just need cleaned to free it from dust build up
on the inner parts this may be causing the unit to over heat
0helpful
1answer

Screen is yellow

use the LCD's Auto Adjust Function. If fails try checking all cables and connections on the back.
Not finding what you are looking for?
LG Flatron F700P 17" CRT Monitor Logo

851 views

Ask a Question

Usually answered in minutes!

Top LG Computers & Internet Experts

Ekse

Level 3 Expert

13435 Answers

k24674

Level 3 Expert

8092 Answers

Cindy Wells

Level 3 Expert

6395 Answers

Are you a LG Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...