Zanussi FS1455W Front Load Washer Logo

Related Topics:

Question about Zanussi FS1455W Front Load Washer

1 Answer

Wont go after setting my washing machine and pressing start it just clicks and go's to finish without doing anything? who or what is 'catriver'? [email protected]

Posted by Neil Gregg on


1 Answer


  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.

    New Friend:

    An expert that has 1 follower.

  • Expert
  • 163 Answers

Hte one that gonna help you just wait...good luck ps it sound to me to be the water level switch..

Posted on Aug 08, 2006


Add Your Answer


Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:


Washing machine tips

<br /> <span>Unplug your washing machine before you do anything. Since you are cleaning your washing machine, you might as well go all out and clean the front, top and sides with the spray cleaner. Clean under the lid and all the surfaces just inside the washer with the spray cleaner. Set the machine to the hot water and largest load settings. Once the machine is full, add the lemon or lime juice if you have rust problems or add the vinegar if you have odor problems. If you have both, do one "load" of each. Let the washer finish the cycle. If you are satisfied with the stain/odor removal, run another cycle on hot at the largest load setting without adding anything to the water.<span><br /><br /><br /></span></span>
on Apr 02, 2011 • Washing Machines

Lid is not locking properly, washer sensor is overfilling, and the washer wont spin

Check door switch: If the lid switch is bad it will not drain or spin. Try this test: With lid open let it finish wash cycle. Press lid switch down with screwdriver. Washer should begin draining. Release switch. Motor should stop. Press switch a second time. Washer should start spinning as it continues to drain. If motor doesn't come on while lid switch is pressed, replace the switch. OR
Pl click if helped.

Washing machine has 1 minute left on cycle stuck door wont open programme not finished

Try the following, may work:
Press the Start/Cancel button together until all the console Led's illuminate
  1. Press both Start/Cancel and On/Off buttons together until 'd off' appears
  2. Default screen should return. Switch off.
  3. Wait for 2 minutes to try the door. If helped click.

Starts ok then skips programmes lights flash then stops without finishin wont complete any programme

starts ok then skips programmes lights flash then stops without finishing wont complete any programme

Washing machine door clicking on and off

if the machine is a zanussi the door lock has to be changed

Washing machine begins the wash cycle going immediately to the agitate cycle, without filling up with water first.

water will not stop running into drum unless shut off at faucet does not happen all the time and wife can't find her rubber boots

Indesit W1A111 starts cycle when selector set to "off"

many indesits have a memory on board, set the timer to off position, turn on the mains press start let the machine finish what it is doing, and it will reset normally, turn off at mains for a few minutes can also do the trick, it sounds like one of the option buttons was pressed and you didn't let the timer finish its course,

My Dryer wont do anything

check your house wiring circuit breaker
Not finding what you are looking for?


Ask a Question

Usually answered in minutes!

Top Zanussi Washing Machines Experts


Level 3 Expert

2511 Answers


Level 3 Expert

85241 Answers


Level 1 Expert

34 Answers

Are you a Zanussi Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides