RCA 36V430T 36" TV Logo

Related Topics:

Question about RCA 36V430T 36" TV

2 Answers

Power on and off repetitive

When pushing power the unit just tries to power up but shuts off and on with video sometimes,but can power off by hitting power button. Pls help with this problem. Thanks, Robert

Posted by Anonymous on

  • Anonymous Aug 06, 2006

    to add to this problem i have looked at this unit for solder crackes and could not find any, this set was given to me, and was told that it might have had a power surge. i have checked the main power and horizontal circuit and looks find no signs of burned or damaged componets.

  • Anonymous Jun 11, 2008

    Tv turns off and on again and again by itself. never gets to the point of a picture on the screen.

×

Ad

2 Answers

Anonymous

I had a RCA MM32110 which had the same problem, turned out to be a sticking fan causing overheating. I cleaned the fan and never had the problem again.

Posted on Feb 21, 2007

Ad

Anonymous

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    New Friend:

    An expert that has 1 follower.

  • Expert
  • 163 Answers

Need more info but it sound to be a cold solder problem,look at the circuit board closely for cracked solder joints. Resoldering any bad joints might just solve your problems, but be carefull there are very dangerous site inside a tv, if you dont know about tvs look for profecional assistances..good luck

Posted on Aug 06, 2006

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Hi I have a 60 inch LCD Sharp Aquos Model LC-60LE600U. When I plug it in the standby light comes on, but when I go to hit power i see a flash on the screen and it turns off. I am thinking it is the power...

I wish it was that easy!! It is either that or the LED lights behind the screen. The OEM pushes those to their limits in order to get the brightest picture. When ONE of them fails, the power board shuts down the unit.
0helpful
1answer
3helpful
1answer

Yamaha Receiver won't turn on after USB plugin in. Help!

Unit is in protect mode. Sometimes an ipod draws too much current through the usb jack and causes the unit to shut down due to an abnormal voltage being detectected. Press and hold the 'info' and 'tone control' buttons and push power. This should turn the unit on. Turn it back off and turn it on again and should power up normally. If the ipod continues to make the unit shut down when plugged in, try and make sure it is fully charged before plugging it into the receiver - this may help.
0helpful
1answer

Panasonic Counter top Microwave model # NNT695SF Often when I push the start button, the microwave will go for a few seconds and then cut out. I then open the door and then shut the door and push the...

Issue with your Main Panel Power Fail to innitiate ..Du to Component mal-functioning inside the unit ...Possibility Magnetron defect, Or main Transformer Over heat, Also check for safety swich on the door for bad connection...
0helpful
1answer

GE PVM2070SMSS Microwave, Unit runs for a sec then shuts off.

Obvious thing is to try plugging in a different receptacle to verify if it might be bad wiring in your kitchen. Make sure to use a different circuit, maybe in different room. If it is the circuit, then likely cause is those plugs with push in back wiring. Replace with ones that wire screws to.
0helpful
1answer

When I power up laptop screen is blank

You may have a burned video adapter.

A trouble shoting setp you can try is attatching an external display and seeing if that works.
Also try the function F5 key combo. I think that is the ASUS mapping to switch display output.
0helpful
1answer

I have a HT-X40 Samsung home theater that worked fine until yesterday. It's been used very little to this point but now it won't turn on. I was watching a DVD yesterday morning then hit the stop button on...

I would say the DVD was stuck in the unit. Try pulling on the drawer whilst hitting eject. Also try pushing on it doing the same thing. Keep on trying to play it also, sometimes the control system and the mechanics get out of synch and need a little bit of help. But first thing - have you tried disconnecting the power completely (at the chord) and leaving it for about 10 minutes? Always a good first thing to try.
2helpful
1answer

Wii shuts down

HI, the power sector has failed in your unit. this will cause the issues you are experiencing at this time. you will need to contact Nintendo at this time. they will issue you a repair ticket so that this unit can be repair. the power sector will need to be replaced(Power component failure).
1helpful
1answer

Alarms

Hello, find the BIOS Beep Codes at http://www.amptron.com/html/bios.beepcodes.html and try to find your problem. It is not a software or Monitor problem. It could be RAM or Video Card failure
Not finding what you are looking for?

114 views

Ask a Question

Usually answered in minutes!

Top RCA Televison & Video Experts

The Knight
The Knight

Level 3 Expert

76851 Answers

Jaime Hernandez

Level 3 Expert

2345 Answers

Cindy Wells

Level 3 Expert

6528 Answers

Are you a RCA Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...