"service call 08 main motor"

Just give up. It is NOT possible to fix ANY such problem, EVER ... unless you REVEAL the MODEL of the printer you are trying to get help with!

hi
Turn off the printer. Wait a few seconds, and
then turn it on again.

If printer within warranty period then contact customer service....it is faulty!

if not then reset by un plugging at mains for 30seconds then plug back in, turn on and wait till warm up and silent.......has it cleared error? If so then print test sheet!

hopefully good to go!

check all image units and fuser also check the transfer belt, something is stopping th main transport motor replace the all ave worse case motor is burned out along with main control board$$$$$$$$$$$$$$$$$$$$$$$$$$

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Hi

If your phone is activated than you miss the "Message Center Number", First call to your service provide and ask to the message center number after getting the number, go to the Messaging>Message Setting>Text Message>Message Center write the number and save.


If my solution fix your problem give me thumb

"Cheer"

This indicates one of 4 problems. They are in this order from easiest to most difficult.

1 Malfunction caused by overload (unplug the power cord and wait 5 seconds then plug back in.
Open and close the scanner cover.

2. ASF encoder sensor defective (Replace ASF motor assy)

3. ASF Motor defective (Replace ASF Motor assy.)

4. Main PCB Defective (Replace Main PCB)

If this is any problem other than 1 above you will need an authorized service center.

Good Luck

Hi Collin,
E511 is a TR0 Sensor Fault. This is commonly caused by:

Photoconductor Unit
SENSOR TR-0
HARNESS-ASSY XERO
MOTOR ASSY P/R
HARNESS ASSY MAIN
PWBA MCU
LV/HVPS

This is not Diy, I've advice you to send the unit to your local Epson Service center.
Hope it may help you.
Have a nice day!

Hello. here is the sharp web site http://sharp-world.com/support/index.html

it has everything u need to know about how to contact them for support and service. J.

Got answer from fixyourownprinter.com. " Service call 08 main motor" means the main motor is not functioning. Could be the fuser siezed up preventing the motor from turning.

This is a wiper error. There is a wiper blade that cleans off the printhead and it is stalled. There might be something obstructing the blade itself ,wiper on the wiper belt incorrectly or a motor is having problems. I would recommend calling a certified service tech to fix it.
Hope this helps