SOURCE: Maytag Ensignia Washer Leaks
I have the same problem. Just took mine apart here is where you can see how to get the front panel off. If I figure out the problem I'll post an update.
Panel opening:
http://www.applianceaid.com/atlantis.html
SOURCE: timer on maytag washer
this is a good one! dependable care unit made in my home town.
http://www.servicematters.com/maytag_library/docs/16010373%20(16001145).pdf
insert flat blade under center plastic clip in the center if timer knob , you will find a little clip and sping here , then remove two 5/16 screws , then remove two phillips screws on control panel , you should see 4 ,2 on each side remove the inside 2 then tilt panel forward unplug timer. so easy
SOURCE: maytag washer mav7757aww
I had the same problem with mine a couple of years ago and it ended up being the transmission was shot. Apparently this is a common problem with this washer. Google it and see.
SOURCE: Have a Maytag Ensignia top load, Washer basket is
sounds like your balancing ring or your springs gave out underneath to balance load
SOURCE: how you open a maytag ensignia washer
The older models had screws at the base to remove. The newest ones have spring clips instead of screwsthis is a dryer but basically you washer fron panel comes off like this when you release the spring clips on each side with a simple putty knife.
If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61
383 views
Usually answered in minutes!
×