Question about Sony STR-DE595 5-Channel Amplifier
My dog bumped into my tv stand which also holds my satellite receiver, DVD and amplifier...moments later, the sound went out. It will not work now with the tv, it works with the DVD and the radio will turn on but I can't hear my tv channels at all. I've checked all the connections and they are intact. What do you suggest if anything? Thanks.
The Dog must have not liked the program? No what you need to do first is check the things that you overlooked as obvious? Such as mute switch, Balance control, Not in the right mode, speakers turned off, Audio cables pulled out of the unit. In tape monitor mode. Thats the most common thing if you have no sound after a bump from the rump of a dog,person playfull partner. Good Luck
Posted on Jun 17, 2006
Tips for a great answer:
The One For All 6-Device PVR Universal Remote Control
is preprogrammed at the factory to operate an RCA TV,
VCR, and satellite receiver, a Philips Tivo PVR, a Toshiba
DVD player, and a Pioneer audio receiver/amplifier.To
control devices other than the default brands,perform
the following steps; otherwise skip this section:
[*] Turn on a desired device (e.g.,VCR or
DVD player) and, if applicable, insert
media (e.g., cassette or disc).
NOTE: Please read steps 2 through 4 completely
before proceeding.Highlight or write down the
codes and device you wish to program before
starting step 2.
[**] On the remote control,press a device key
once (i.e., TV,PVR,DVD, CBL/SAT,AUD,or VCR).
NOTE: To program control of a cable box or
satellite receiver, press CBL/SAT once.
NOTE: To program control of a CD player or
audio receiver, press AUD once.
NOTE: To program control of a TV/VCR Combo,
press VCR once.After programming, you will be
able to control channel selection, volume, and
NOTE: To program control of a TV/DVD Player
Combo, press DVD once.After programming,
you will be able to control channel selection,
volume, and DVD functions
[***] Press and hold SET until the LED (red light)
blinks twice, then release SET.
[****] Use the Manufacturer's Codes of device and
brand name and then enter the first fourdigit
code for your device. If performed
correctly, the LED will blink twice.
NOTE: If the LED did not blink twice, repeat steps
2 through 4 and enter the same code again.
[*****]Aim the remote control at the device and
press POWER once.The device should turn
off. If it does not, repeat steps 2 through 5,
trying each code for your brand until you
find one that works.
NOTE: If the device does not have a POWER
key, press the (Play) key
[******]Repeat steps 1 through 5 for each device you want to control.
Usually answered in minutes!
Step 2: Please assign your manual to a product: