DVD stuck in changer

Hi i have penasonic vk90d after i service the unit . The unit is stuck on dvd but nothing works dvd tape fm aux nothing work the unit is stuck on dvd changer. Any body help me plz
[email protected]

on the front face of the dvd is a tiny hole which you slide in a rod or pin which releases the locking catch

same problem with me... did u managed to resolve??

After some time it was showing some C 31 00 error. I searched on internet, opened the top cover, there is the CD changer and my cd was stuck in there, I pushed the CD from finger and there it goes... on press of eject it came out... thanks anyway...

Disclaimer: I am not a professional. This is an account of what I did to replace my DVD changer. If I had been offered the $450 installed option, I would have taken it.

According to the boys at Car Toys and the dealer, once these DVD changers go, they have to be replaced. The dealer quoted me $705, but I found one on E-bay from a highly rated seller for $400. I was able to pull out the DVD changer by popping off the trim betwee the DVD player and the cup holder, and then removing two screws. Note that it may help to remove the cup holder.

Once those two screws at the bottom are removed, it just takes a firm tug on console shell below the DVD player for the whole face of the console to come off. Disconnecting the airbag indicator connector will allow the console face to be pulled far enough away to get at the DVD changer. All connectors have a tab you need to press while pulling.

Two more screws need to be removed to get the DVD changer out. With those screws removed, another firm tug and wiggle will release the DVD changer. You'll probably hear a metal popping sound, which is just the rear grounding tab (I think that's what it is) pulling free from the cage.

Once you can reach the two wiring harnesses behind the DVD changer, pull on the wire bundle to give yourself some slack to work with, while not stressing the cable assemblies too much. Disconect the two connectors at the back of the DVD changer. At that point the DVD changer can be removed, and you can search on E-bay for the part number. My unit had a complete wiring diagram for the two connectors on the sticker, but I couldn't find anyone with the right connectors to install an aftermarket system.

I haven't received the new part yet, so I'm a little nervous about the correct order of connector installation. I'll probably pull the battery terminals while installing the new unit, but here is where you are on your own. Good luck.

you have the amp remote wire hooked to the power antenna lead instead of the amp wire on the deck otherwise just hook it to a switched +12 volt source. You sure you got a DVD changer instead of just a cd changer

I have a DVD player, a VCR player, a TV set all hook into an RCA RT2250 Audio/Video receiver. Everything was working fine until 2 days ago. Now the DVD player gives me a great pix but no sound. The VCR,and TV are just fine and I have checked everything out, speaker connections, mute buttons, etc. and nothing seems to be wrong. I am thinking that some thing in the receiver got fried. Is it repairable?

I had the same problem... my DVD took one in even though it already had one in there... Tweezers did not work until we used a pie server covered in masking tape with the DVD attempting to eject and then grabbed one DVD out. The DVD player works too!

Remove the screws to manually open the player and without disturbing the connection try to remove the dvd . This problem caused by motor ,which is not working properly .

Try to look in the dvd player's instruction booklet for an ejection hole. Ususally dvd players have a hole where u stick a paper clip into it and it ejects the dvd. If not, contact the vehicle's dealership for assistance.